Electronics Forum | Fri Mar 06 08:58:15 EST 2009 | tech1
We are not happy at all about this one. I guess Due Diligence was not a concern when my boss was wined and dined.
Electronics Forum | Wed Mar 18 17:41:15 EDT 2009 | gregf912
Chris, Go to IBE and get the LCD monitors. The kit fits the CP6 and the resolution is much better that tne factory ones.
Electronics Forum | Fri Mar 19 10:27:42 EDT 2010 | karlo
No clean pastes leave more flux residues. These can result in void formation and inhibtion of underfill curing. Selection of an underfill that is compatible with the flux residue is important. One company that has written about the effect of flux
Electronics Forum | Thu Mar 05 05:43:40 EST 2009 | ghcarnu
Searching the marketplace for mantis returns old data. I'm looking for buying a couple of Mantis microscopes; has anyone them for sale?
Electronics Forum | Mon Mar 09 11:05:07 EDT 2009 | KP
The mydata machines are using different packages. Since we know the part numbers and packages affected, would it be posible to load some sort of offset file to correct this before sending it to the machines?
Electronics Forum | Fri Mar 20 01:09:26 EDT 2009 | padawanlinuxero
Have the same problem but I do it manually in MYDATA when I check the feeder�s position I can change the orientation there.
Electronics Forum | Mon Mar 09 09:28:16 EDT 2009 | davef
Bob Willis and Phil Zarrow have published recommendations in this area. * Search the fine SMTnet Archives for references to their findings. * Read posted papers on the topic on their sites.
Electronics Forum | Mon Mar 09 11:43:59 EDT 2009 | pcbrown
Here is a formula that may help. C/P C= Component's weight in grams P= Total pad area in Sq. in. Must be less than or equal to 30 Parts larger than a 68 pin PLCC should use an adhesive. Hope this helps.
Electronics Forum | Wed Mar 11 09:28:34 EDT 2009 | wrongway
surface tension is what holds the parts on when solder is flowing I would add some glue under the parts that I placed on the frist side the glue will add more surface tension. this is if you have a glue dispencer in your line already.
Electronics Forum | Wed Mar 11 12:33:28 EDT 2009 | realchunks
Make sure your oven conveyor is running smooth as well. One bump or bad vibration will knock parts off too. Lowering the bottom zones in spike zones will help too.
