Electronics Forum | Fri May 04 20:14:38 EDT 2012 | hegemon
From my past experience, of those 5 I would go with Mirtec. Easy programming, and great support. A pretty well thought out package for the $$ I have no affiliation with, nor receive any benefit from any company mentioned above. 'hege
Electronics Forum | Mon May 07 08:09:14 EDT 2012 | tommyttr
Go with YesTech. They are tried and true. I have been using them for years. Top notch company all around.
Electronics Forum | Tue May 08 14:22:18 EDT 2012 | scottjwarren
Wow! Thanks for the replies, everyone. Lots to digest. I'm going to take some time to do some research in these various directions and may have more questions. Thanks again for the recommendations and advice.
Electronics Forum | Tue May 08 13:07:07 EDT 2012 | joeherz
This isn't the correct forum for material availability issues BUT here is a contact that we have used for difficult to find parts - Mac (Michael) La Barbera, MLABARBE@americaii.com. Good luck.
Electronics Forum | Wed May 09 08:48:51 EDT 2012 | leemeyer
Try going into the program definition screen and delete the permanent table top. Then shut down and reboot. The permanent table top will be re created upon reboot.
Electronics Forum | Tue May 08 16:36:41 EDT 2012 | warwolf
has anybody have any experience with this eco-friendly stuff? http://www.fluxcleaner.com/category/1-flux-cleaner.aspx and are there any others that are better? and just general flux cleaner discussion Regards
Electronics Forum | Thu May 17 23:32:10 EDT 2012 | umar
Hi Dave, Thanks on yoru prompt reply, Can help to share whethere you had knowledge about this issues ?since I had a hot topic on this issues ? is my cleaning is not clean or is the saponifier chemical uyse is not compatable to the humiseal coating
Electronics Forum | Fri Jun 01 06:40:39 EDT 2012 | umar
Hi Norman... Thansk on yoru input, actually my adhesion test conduct is after pass of IC test. MY IC Test is shown a good result but when go into teh Test adhesion coating then during peel off test my board was failed.
Electronics Forum | Fri Jun 08 09:47:19 EDT 2012 | duso02
Umar, it may never be solved. Some coatings just do not stick to some substrates. Have you tried using a different coating? Even changing to 1B31S may be enough. Or 1B73 acrylic. Also, look into Nexus3C.com.
Electronics Forum | Wed May 09 04:17:49 EDT 2012 | umar
HI SMT Forum, Right now I am looking for the equipment to measure of my coating thickness that apply to the PCBA process. my chemical type is use acrylic and polyurethane type. If any one of the forum knowing about that, I would like to have on you