Electronics Forum | Wed Nov 18 20:58:39 EST 2020 | kumarb
You should contact Irv or Rudi at asys-group.com in the USA. They are great for technical support.
Electronics Forum | Thu Nov 19 08:46:57 EST 2020 | ushir
Hi Bob Please may you send me the Ekra E5 service manual to ushdogg85@yahoo.com I appreciate your assistance. Thanks
Electronics Forum | Mon Dec 14 17:16:15 EST 2020 | vielki
Hi Bob, Can you send me manual ? my mail master_tail@op.pl
Electronics Forum | Sat Dec 19 04:08:25 EST 2020 | 712116
Helloo Bob, Could you please send me a copy of the manual. EKRA E4 model Service Manual PDF email address is tct7989@gmail.com. Thank you sir.
Electronics Forum | Mon Jun 26 11:40:40 EDT 2017 | aqueous
We have no record of this request. Please contact service@aqueoustech.com and they can supply a manual. -MK
Electronics Forum | Fri Jun 23 09:11:06 EDT 2017 | jchris
I have a few LED pcb's that have an aluminum substrate that are ridiculous to rework. They heat-sink like crazy and I can't reflow the bad LED's, no matter how much heat I apply. Any suggestions on techniques or equipment to use?
Electronics Forum | Fri Jun 23 12:11:26 EDT 2017 | rgduval
I haven't tried doing these, personally...but... - Try a pre-heater? - IR rework station? Off the top of my head, that's all I've got. Cheers, ..rob
Electronics Forum | Sat Jun 24 10:10:31 EDT 2017 | fugtussey
Here's a good IR preheater that you should look at: www.paceworldwide.com/products/smt-rework-systems-and-preheaters/preheaters/ph-100-low-profile-pcb-preheater
Electronics Forum | Fri Jul 07 15:00:19 EDT 2017 | emeto
A picture shows more than a thousand words. If you show us the LED and PCB if possible, I am sure people here will come up with some ideas.
Electronics Forum | Fri Jul 07 16:52:20 EDT 2017 | tombstonesmt
We had very little success reworking these type of boards. We used a BGA repair station and still was a major hassle. Are these shifted LED's or defective?
.gif)
