Electronics Forum | Fri May 24 09:16:36 EDT 2013 | grahamcooper22
you need to reduce your time above liquidus to as low as you can...maybe 10~30 secs to allow the solder to wet to the gold but minimise the amount of gold that is dissolved into the solder joint...try also reducing the peak temp to 200~210 deg C. Thi
Electronics Forum | Sat May 04 11:24:08 EDT 2013 | amelby
Hi, I have been having a problem with my My19E's hydra. The machine comes up with an error "Failed to locate HYDRA tool reference marks" and stops running. It does not happen for about the first two hours of running. It starts to happen after that an
Electronics Forum | Sat May 04 14:36:53 EDT 2013 | dontfeedphils
It's been a while since I've used a MyData but I believe what happens is on the bottom of the hydra black metal piece is a mark that the vision system uses to locate the tools as they pass over to center the parts. Something may have happened to this
Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
Electronics Forum | Sun May 05 17:27:32 EDT 2013 | davef
Here’s a Tweet that I made here [http://blogs.smtnet.com/smt/smt-placement/ipc-apex-2013-my-tweets/ ] … Hisco’s computer controlled frig for managing solder paste inventory … way more sophisticated than that old white frig. Davef I receive no benefi
Electronics Forum | Tue May 14 15:21:07 EDT 2013 | Keith Cathcart
I've seen a couple of customers create a jar dispenser similar to the ones you can buy for beverage cans. See this link for the examples used for beverage cans http://www.meijer.com/shop/chrome-organization-kitchen-storage.jsp Hope this helps. Kei
Electronics Forum | Tue May 07 09:26:38 EDT 2013 | emeto
Hello knowledgeable people, we have Omniflow 10Zone oven from 3-4 years and we changed over 20 blowers. The blower is German and I think is a very good quality(quite expensive too), but still keep getting bad. Does anyone have similar problem? Do yo
Electronics Forum | Thu May 09 16:54:43 EDT 2013 | smter
We used to have similar issues with large fallout on ours. I have been writing the date on mine for the last few years. We were having premature fallout due to our techs not installing them with proper screw installing pattern, which seemed to be cau
Electronics Forum | Wed May 22 12:59:09 EDT 2013 | cyber_wolf
That sounds very odd what smter is saying. The screws around the outside of the fans have nothing to do with the bearings. You only really need to tighten those screws enough to squish the gasket a little. No special torque settings required. As lon
Electronics Forum | Tue May 07 13:32:15 EDT 2013 | bobpan
Sounds like you may have a z-axis problem. I would check the axis out and run the z rod up and down by hand to see if there is a problem....sticking,sensor/flag broken....etc. Maybe you can unplug the z-axis card and then turn the machine on to see i