Electronics Forum | Thu Sep 08 15:45:21 EDT 2016 | claudea2
Thanks Bob, I will change the z-rod just to make sure. It is a tall part read at 180. The nozzle height bugs me because we have 3 machines and the first one has a nozzle height of 238 while the 2 others around 200. I am thinking this parameter may ad
Electronics Forum | Thu Aug 25 16:39:40 EDT 2016 | jserpas
Hello, I am curious if anyone knows of an easier way to straighten Fuji feeder baskets for CP6 machines. Are there maybe any specific jigs out there that would help with this? Has anyone ever ran into having baskets tweaked on these feeders and found
Electronics Forum | Wed Aug 31 17:23:00 EDT 2016 | corepride
Hi everyone, I have a problem with the 630 VME vision system: during startup machine, an error popup appears saying "Did not receive request to load machine model within timeout period. Possible machine error condition exists. Do you want to continu
Electronics Forum | Mon Sep 05 16:24:09 EDT 2016 | davef
inspect => conformal coat ... and standards are aligned with that philosophy. I can imagine doing a good job inspecting assembly after being coated with particular coating thickness, optical properties, lighting conditions. Ultra-thins are so thin
Electronics Forum | Thu Sep 08 04:36:06 EDT 2016 | jasltd
Hi there, I'm looking to add automatic label application to my SMT line and I'm looking for people's feedback on what options they have tried and what has worked well for them. The volume isn't hugely high but I need the label to be consistent and o
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin
Electronics Forum | Thu Sep 15 06:45:26 EDT 2016 | awhite
Hi Ariss_T, Thanks! I actually did check that...that was one of my first thoughts as well. While in the I/O, I slide a raw board back and forth under the camera/sensor and it acted appropriately. I will definitely update this thread as new informa
Electronics Forum | Thu Sep 15 08:01:34 EDT 2016 | leadthree
Hi there, we accumulated over the years quite a lot electronic components (R, C, IC etc.) and some populated modules. What is a good what to get offers for them? We tried ebay, but that works too slow. Some we like to sell in roughly sorted bulk, b
Electronics Forum | Tue Sep 20 13:10:24 EDT 2016 | ladmo1
Have you encountered this? There is black plastic from underneath the chip - oozing out between some of the solder. Like the part melted from underneath. It wasn't even under the chimney and had no direct heat on it. I am afraid if I try to remove
Electronics Forum | Thu Sep 15 15:27:50 EDT 2016 | rvines1
Has anybody else had issues with shipping circuit boards in static shield bubble bags? It appears that parts are getting ripped off during shipping. I suspect that they're getting caught in the bubbles when the boards shift in the bags as the boxes