Electronics Forum | Thu Jun 13 08:46:20 EDT 2013 | markhoch
It sounds like they are referring to Low-Pressure molding, which was designed specifically to encapsulate electronics. I have seen some products that were processed on polymide flex, and then overmolded in this process. I would start by contacting "
Electronics Forum | Fri Jun 14 05:49:32 EDT 2013 | rollon65
Hi all. I used a 5/16" white paper sticker to mark a reject PCB in a panel of 10. One of my my Quad 4Cs sees it O.K. and marks the PCBs reject. The other machine either shows them all reject or shows the marked one as good and the other 9 as rejec
Electronics Forum | Wed Jun 19 07:24:10 EDT 2013 | bobpan
Hello Rollon, There needs to be a contrast between the sticker and board. The manual gives and example of a round red sticker. If you still cant still make this work.....Do the following. Run the machine and after it finds fiducials press stop on the
Electronics Forum | Fri Jun 21 03:11:29 EDT 2013 | rollon65
Hi Bobpan. Thanks for the reply. I had already tried red stickers as suggested in the manual, then blue then silver but none of those worked so white was my last resort. I'm running 3 machines in tandem and they all start at the same time so stopp
Electronics Forum | Mon Jun 17 09:52:33 EDT 2013 | sara_pcb
My circuit board contains 11 x 11 matrix 1mm pitch BGA, The device was tested in socket on evaluation Board. We handed over the actual PCB & devices for re-flow. The assembly house first re-flowed all the SMT components other than BGA. BGA was placed
Electronics Forum | Mon Oct 21 09:22:56 EDT 2013 | sara_pcb
One of our PCB for high reliability application is having 2 BGAs(11X11, ADV 204), The pitch is 1 mm. We decided to wire the BGAs first using re-flow soldering and the rest of the components by hand soldering. Since the PCBs are for high reliability a
Electronics Forum | Tue Jun 25 07:48:32 EDT 2013 | bin95
I agree with everyone else here, 3-6 months for blowing dust out of panel a bit excessive, once per year will be fine in most environments. If you find it needs to be more frequent, you need to explorer dust preventative measures. (Check panel seal,
Electronics Forum | Tue Jun 18 11:16:39 EDT 2013 | dontfeedphils
Those are nozzle attaching and removing errors, meaning the machine is having a hard time picking up and leaving nozzles. In the head there should be a rubber o-ring, it often needs to be either cleaned and oiled (Juki has a specific oil, make sure
Electronics Forum | Tue Jun 18 15:33:22 EDT 2013 | abrown615
Hey everyone, Our company just picked up a Quad IV C/115 pick-&-place system from one of our offices that closed, but we do not have the documentation for it. It looks to be a very old system so I can't find it anywhere online and we just don't know
Electronics Forum | Wed Jun 19 11:34:37 EDT 2013 | chifutbol
"The disk of B drive has not been formatted as a PCB Data disk." This is the error I'm getting when trying to install lines on a new installation of the Gemline PCB Editor. I have tried using a new floppy, formatted in both opal and topaz machines,