Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Tue Oct 27 03:22:43 EDT 2015 | pvogel
I'm looking for some SMD shims or something to solve this problem. We have a coin cell on a PCB and the side that contacts the PCB also has traces under the cell that don't connect to the cell. So I'm after some small dots of something suitable for
Electronics Forum | Mon Nov 02 10:43:13 EST 2015 | dyoungquist
As for cost, that will depend on several things.... -Turn key or consignment? -Diversity of components? -Total quantity of components to be loaded? -Single or double sided SMT? -Individual boards or are they panelized? -No clean or water soluble flu
Electronics Forum | Thu Jan 07 17:25:24 EST 2016 | hegemon
Not sure how anyone could pretend to "ballpark" a cost for a board, regardless of size, especially in small quantities. You might need 10 assemblies, but the MOQ for your main component might be 100, 200, 500, 5K pcs. Makes me laugh every time I
Electronics Forum | Fri Jan 08 01:24:34 EST 2016 | sunnyduan
What's the best company for low volume, quick > turn around PCB assembly? > > Why do you choose > their service over others? What's the cost > ballpark for 10 3"x3" boards assembled? > What's the best company for low volume, quick > turn arou
Electronics Forum | Fri Nov 06 02:55:10 EST 2015 | arct1c
Hi, we are looking for 1 or 2 new postreflow AOI machines to replace our old ones and possibly 1 prereflow AOI(we never had pre reflow before). In our company we run low volumes and high volumes. I have been looking at Viscom, Mirtec mostly, Cyberop
Electronics Forum | Mon Nov 16 05:55:29 EST 2015 | bobpan
Hello, Average correction should be used. If the nut on the z-rod is what you are seeing through the parts leads...you can use a smaller o-ring and slide it up to where the nut is to block it out. You may have to try a few sizes and/or even double ov
Electronics Forum | Sat Nov 07 18:18:58 EST 2015 | ttheis
Hi everyone, We just got our first wave soldering machine operational (novastar 8s) and its working great. I'm just a little unsure about how to best maintain the foam fluxer daily. Do you drain it from the machine each day or just cover the flux t
Electronics Forum | Sat Nov 14 07:37:46 EST 2015 | tjabas
Hi! i have probems with this asus eee 1001px computer, it wont charge anymore, and i have located a burned diode. I have tried to see what kind it is, but i cant figure it out, i have used a usb microscope to take a photo of it. could you please he
Electronics Forum | Mon Nov 16 09:32:54 EST 2015 | henrikk
I am about to disassemble a Fuji CP4-2 chip shooter machine and I was wondering what are the most valuable parts that I should save and maybe put up for sale. Unfortunately I do not have a lot of storage space, so I have to throw many of the bigger p