Electronics Forum | Wed Oct 26 22:39:01 EDT 2022 | sarason
This is not really a bug. The logic is this if you place a component beyond the edge of the board, it should falloff! So instead on having a very complex algorithm to work out component centres and then make a judgement as to whether the connector is
Electronics Forum | Fri Oct 28 13:48:30 EDT 2022 | proceng1
Well, I'm not sure about the "Trust me" button. I assume you can't tell it the part is smaller than it is because then vision won't accept it. I often add 10mm or so in X direction. In fact, when I measure the board, I just round the X up, becaus
Electronics Forum | Fri Oct 28 14:09:39 EDT 2022 | ttheis
Allowing a part to go over the board boundaries can cause collisions when boards are nested. The software on these machines has limitations but it is plenty capable and rooted in preventing physical damage to the machine. Once you are familiar with t
Electronics Forum | Mon Oct 31 19:30:24 EDT 2022 | ninevoltz
We recently bought three used AX201 machines and a copy of Siemens Valor Process Preparation NPI software to program them. Does anyone have a copy of the K&S Optimizer software that connects with Valor to generate the NC program and run Virtual Stick
Electronics Forum | Wed Nov 02 11:01:56 EDT 2022 | tommy_magyar
Ellaborating on Evtimov's answer: - solder paste type, think about solder granulation and viscosity. Both of these will directly affect print quality if wrong print parameters used. You will normally find recommended print parameters on the solder pa
Electronics Forum | Thu Nov 03 07:46:07 EDT 2022 | umar
Hi Team Members, I am a PCBA manufacturing assy process, we have a V groove and Hole type panel boards that running at my production side, Any one can advice whether the router machine is suitable for those V groove panel PCBA ? or router only ap
Electronics Forum | Thu Nov 03 11:31:51 EDT 2022 | proceng1
You described cleaning the spindles and filters, but did you clean the nozzles? Perhaps you got some paste on the nozzle. Also, did you perform the vacuum and blow off testing? Make sure your solenoids are working properly. Is it all 6 heads that
Electronics Forum | Thu Nov 10 23:43:33 EST 2022 | sarason
Are you using the correct nozzle for 0402? Cant remember the number OTTOMH but 501 rings a bell. somewhere I have the table, it is in the Juki service manual IIRC. This would explain placing all others okay but 0402 is not very good , Senoirtech is c
Electronics Forum | Fri Nov 11 01:32:41 EST 2022 | cooper
Hi Sir, Wish you good day. We have what you are looking for. we discovered that you are looking for SMT line equipment, is it right? our factory main business is all kinds of SMT line equipment would you like to see our machine catalog? YOUR Coo
Electronics Forum | Fri Nov 11 03:09:06 EST 2022 | angela t
Hello, have a good day, I personally recommend the Samsung machines. In the performance of the equipment, Samsung chip machine both in the hardware base or in software, are with high security quality, it is compared with other brands of chip machine,