Electronics Forum | Wed May 27 22:10:25 EDT 1998 | Greg
| | I'm looking to increasing my prototyping capabilies by getting some automated pick and place equipment etc. Any leads on where to start investigating? I'm a very small job shop with 5 employees. Any help would be greatly appreciated. | Greg:
Electronics Forum | Thu May 28 12:11:34 EDT 1998 | Dave F
| | | | I'm looking to increasing my prototyping capabilies by getting some automated pick and place equipment etc. Any leads on where to start investigating? I'm a very small job shop with 5 employees. Any help would be greatly appreciated. |
Electronics Forum | Thu May 28 21:43:52 EDT 1998 | Greg
| | | | | | I'm looking to increasing my prototyping capabilies by getting some automated pick and place equipment etc. Any leads on where to start investigating? I'm a very small job shop with 5 employees. Any help would be greatly appreciated
Electronics Forum | Mon May 18 17:59:06 EDT 1998 | Richard Jackson
I've tried every thing I can think of. Do you have any Ideas? What I have is micro balls on the gold fingers of panelize boards. These balls only appear on the gold finger. Or at least I can only find them on the gold fingers. What I have tried so
Electronics Forum | Tue May 19 16:24:32 EDT 1998 | Earl Moon
| Earl, | I admit that I missed your article since I seemed to have let my subscription to Circuit Fabrication Magazine expire. I am interested in your experience in this area. Is there a way to get a copy of your paper? Could you maybe post it to
Electronics Forum | Fri May 15 16:21:25 EDT 1998 | John s
| If you have a chance check out the MSD artical (Page 69) in April Electronic Packaging & Production. It is one of the worst articals with unsubstantiated conclusions I have ever seen. Notice Figure 3 on page 72, Caption indicates two simular comp
Electronics Forum | Sat May 16 05:48:02 EDT 1998 | Wayne
| Don't ya' just hate that kinda' stuff? The ones that always get me is when some company is advertizing a pick and place machine, and they have a picture of a board in the machine, under the nozzles, that's supposedly getting placed... the only prob
Electronics Forum | Fri May 15 17:59:31 EDT 1998 | Earl Moon
| | If you have a chance check out the MSD artical (Page 69) in April Electronic Packaging & Production. It is one of the worst articals with unsubstantiated conclusions I have ever seen. Notice Figure 3 on page 72, Caption indicates two simular co
Electronics Forum | Thu May 14 16:25:35 EDT 1998 | Chrys
Last week I posted a message on rotary chip waves that stated that the drive shaft had a protective boot around a u-joint that degraded and exposed the joint. Someone from the manufacturer read it and contacted me. He told me the problem has been re
Electronics Forum | Thu May 28 15:56:26 EDT 1998 | John
| Last week I posted a message on rotary chip waves that stated that the drive shaft had a protective boot around a u-joint that degraded and exposed the joint. | Someone from the manufacturer read it and contacted me. He told me the problem has bee
winsouce.jpg)
.gif)
