Electronics Forum | Sun Jun 09 21:10:11 EDT 2019 | don_julio
In our reflow oven it has pins which move at the predetermined speed to move the pcb through the various zones in the oven. The forward row of pins is fixed along the front of the oven. The rear set of pins is adjustable per the width of the pcb. We
Electronics Forum | Sat Jun 22 07:38:58 EDT 2019 | emanuel
We have a printer with Hawkeye 1700. The PCB side sometimes returns a distorted picture. It happens erratically, can be at startup or after a while, sometimes the machine works full day without problems. The only way to restore operation is disconnec
Electronics Forum | Tue Jun 25 22:22:22 EDT 2019 | proy
We have an electrovert 16" econopak wave solder machine with two identical pots (exchange between Tin Lead and Lead Free). When the pots are exchanged the same thermocouple is used, and the same controller is used - with the set point adjusted. The S
Electronics Forum | Sat Jul 13 11:14:55 EDT 2019 | SMTA-Richard
Yes, it is time and temperature, but it is also speed and distance. Even though you can run a longer machine faster, the boards have a longer distance to travel and you do too, so the cycle time per board may not improve be reduced as much as you th
Electronics Forum | Tue Jul 16 02:18:42 EDT 2019 | sy332366
Specifications : S-8800 Number Of Heating Zones :Up8/Bottom8 Dimension (L*W*H)mm: 5310x1353x1490 Dimension (L*W*H)mm: 5310x1353x1490 Number Of Heating Zones : Up8/Bottom8 Length Of Heating Zones : 3121mm Control System : PLC+Computer Transmission Age
Electronics Forum | Mon Jul 01 14:46:47 EDT 2019 | assuredtech
It's been awhile but yes, if you do not allow the machine to optimize your program and your placing sequence is such that the tallest component is perhaps the 1st or last placement so it doesn't bump into other components, next is you may look into a
Electronics Forum | Sat Jun 29 04:11:31 EDT 2019 | jackson_jade4
Well, I know that this is not directly related to the pycom device, but the code and load cell are connected to the device so I am hoping to gain from the wealth of knowledge and experience on this forum. Until a few weeks ago, I knew nothing at all
Electronics Forum | Mon Jul 08 12:21:17 EDT 2019 | slthomas
I forget which type of CTA that machine has so I probably won't be much help. It's been ages since I worked on them but it doesn't look like you'll find many people that have. That said, usually if you get things aligned properly and it still bends
Electronics Forum | Mon Jul 08 16:03:06 EDT 2019 | slthomas
My recollection is that there is a carrier clip locator that positions (centers) the clip in front of the CTA. Has the adjustment on that been confirmed as well? (Edited because some of it's coming back to me!): I think there is a diamond shaped pin
Electronics Forum | Wed Jul 24 09:50:20 EDT 2019 | amitthepcbguy
To perform conformal coating of PCBs in high power electronics applications follow IPC-A-600F and IPC-CC-830B conformal coating standards. This standard enlists several performance criteria. Additionally, this standard is considered as a good referen