Electronics Forum | Wed Nov 20 16:27:15 EST 2002 | pjc
FYI: MPM does in fact offer alternate board support tooling than the vacuum box system. They have the X and Y snugger tooling, which clamps the board and uses magnetic support pins. If you are looking at a used UP2000, check to see what tooling it ha
Electronics Forum | Thu May 01 13:58:14 EDT 2003 | bremerg
Gentlemen, Does anyone have any failure information on IRC, CHP2-100-R500F (5 OHM, 2W, 1%) resistors. We have experienced two failures on the same circuit board where the metalization on the component separated from the component causing an open ci
Electronics Forum | Fri Jan 30 09:55:34 EST 2004 | Mark
I was wondering if anyone is using Fuji Flexa yet first of all. And if so what form of CAD socketing and documentation did you get? At the moment I run SMT programming (FujiCam) and Doc Control(Unidoc) so I will be seeing the whole picture. This will
Electronics Forum | Wed Apr 14 08:30:24 EDT 2004 | Mark
Well, it's been a month and I have used Flexa (Fuji America) and Circuitcam (Aegis). I do enjoy circutcam alot better than our Unidoc visual documentation. The customer support is off the hook and easy to deal with and software is operator REALLY fr
Electronics Forum | Fri Jun 25 13:00:48 EDT 2004 | haviland
Hi--We deal in used and recond. equipment in the Midwest, and have available a 1999 Amistar #7100FV w/ a nice complement of feeders, (6) pick up heads, rated component placement at 18,000 pph. Does .0402's, .3 BGA w/ 20 mil pitch, Full vision system,
Electronics Forum | Wed Aug 18 06:20:42 EDT 2004 | Bernard Mulcahy
Thanks for the Feedback -- Yes the hard-disks is taking a dump -- This will be the fourth new hard drive since I did the upgrade from Tpsys 1.6 to Tpsys 2.2 Mydata can't really come up with a reason --I can't believe that I am just being 'unlucky' g
Electronics Forum | Thu Dec 09 04:21:22 EST 2004 | chad
I have worked w/ the GSI SVS 8200's. They seem to do a pretty decent job, but, they are a "bottleneck" on my lines. I hope you are using good screen printers, because they WILL find the slightest "defect". About 75% of our failures are actually fa
Electronics Forum | Mon Feb 21 16:06:10 EST 2005 | MR
I agree w/ JB; the package height definition is crucial. I have had problems w/ this in the past, and found that a resistor height was being used as a universal passive height for the capacitor in question. Properly defining the height fixed the pro
Electronics Forum | Mon Jun 13 10:28:29 EDT 2005 | andymackie
I've had a lot of experience with solder spatter. It's usually related to moisture (humidity) uptake by the paste, or outgassing from plating: particularly Au/Ni. Solder spatter from the plating will change from board-vendor to board-vendor. I shoul
Electronics Forum | Fri Aug 17 14:16:09 EDT 2007 | mika
No it is not any "western known" standard. Of course it is a binary type of data. But yes, it is possible to trace the RS232 data stream and interpret et the actual info. I know that this has been done before. You might want to just take a phone ca
