Electronics Forum | Fri Sep 01 18:13:59 EDT 2006 | Cmiller
I find it interesting as well. China may end up as thier biggest market. It is common on consumer electronics that the people in China do not want goods made in China because of perceived poor quality. On the other hand, if UIC did not source some
Electronics Forum | Mon Sep 11 10:35:32 EDT 2006 | Gus Widmayer
Hi Dexter, Your problem may not be with the feeder itself but with the quality of the tape you are receiving. OX3 Corporation performs a peel test on every single line item that is processed through its facility. You may want to check with your cu
Electronics Forum | Wed Sep 13 12:42:48 EDT 2006 | russ
much prefer using percentage instead of fixed overage. Example.... A run needs 100,000 parts, (1% shrink is 1000 parts!) you want to only issue 60 over? I recommend 2% for popcorn and exact for retrievable/ identifiable parts like sticks and trays
Electronics Forum | Tue Sep 19 09:50:23 EDT 2006 | billyd
Dude - The last I knew, two employees had bought out service contract rights from SRT when they went away. It was incredibly pricey to have them come in, as they then wanted huge money up front for a two or three year deal. Get in touch with: VJ Elec
Electronics Forum | Thu Sep 21 08:06:15 EDT 2006 | bobpan
I think 365 is ok. You should check and make sure the z-rod's spring is ok. Just make sure it is not sticking. Dont waste your money on the pm. If you want a complete list of things to do.....leave an e-mail address and i can e-mail you a list.
Electronics Forum | Thu Sep 21 14:29:58 EDT 2006 | realchunks
Gotcha, I used to be in charge of a pneumatic gun that clipped and bent the leads. Hand held units that worked rather well. The operators where very good at aiming the clipped lead too! Anyway, you may want to visit Panasonic, they have/had a disp
Electronics Forum | Fri Sep 22 08:37:54 EDT 2006 | Rob
Hi, you want something that will not break down, and something not American then. I would look at the Fuji XP-143E (if you are not going bigger than 20mm x 20mm) or the Juki then. Also I would look at what they are predominately using in Turkey, as
Electronics Forum | Mon Sep 25 09:47:34 EDT 2006 | SWAG
Not sure if this will help at all but you might try doing a lighting histogram test/adjustment since you have a new camera. It could be that your lighting is very bright or too dim and the camera is confusing features next to your intended fiducials
Electronics Forum | Mon Sep 25 14:57:53 EDT 2006 | jdengler
John, Your calculation looks fine. If that's all you were looking for your done. If you really want to produce more boards per day we would need more info. Size of board, can it be panelized or larger panel. Your line configuration and what mac
Electronics Forum | Wed Oct 11 15:40:34 EDT 2006 | Steve Gregory
Don't think there's any easy way to clean under a LCC, but you might want to consider this: http://www.winslowautomation.com/ccmd.asp A dead simple way to mount solder columns onto LCC's and then solder the part to the PCB with a stand-off of abou