Electronics Forum | Wed Aug 25 23:11:40 EDT 2004 | pdeuel
Is your video working if it is then dont worry about it. Cognex runs the video display. Our machine reports cognex not found also. With ours we have a Cognex mounted on the side of the machine I believe it's a cognex 5,000. From what I understand the
Electronics Forum | Tue Aug 24 14:49:21 EDT 2004 | Rush Fan
I was notified that one of our operators took it upon themselves to run a board assembly through our reflow oven multiple times when he discovered what looked like incomplete reflow. Based on this being done, its been asked of me how, if any, has the
Electronics Forum | Tue Aug 24 21:52:06 EDT 2004 | rose
recently I met one very interesting issue with my board and connector. substrate of the board is copper with immersion silver, pad size is about 3x1mm. we print lead-free paste on the pad, then put the connector on the paste. The board was reflowed u
Electronics Forum | Wed Aug 25 20:48:17 EDT 2004 | rose
Hello recently I met one very interesting issue with my board and connector. substrate of the board is copper with immersion silver, pad size is about 3x1mm. we print lead-free paste on the pad, then put the connector on the paste. The board was refl
Electronics Forum | Fri Aug 27 00:26:14 EDT 2004 | charly
hi, encounter few cases PCB was delam after reflow, and the supplier was refuse that this is a PCB manufacturing defect as the fallout is low within one lot. the cost for this scrap is high after PCBA level, my query here are 1) is there any way
Electronics Forum | Fri Sep 10 09:39:32 EDT 2004 | Bryan Sherh
Dears, I've a board with OSP surface finish,and I planned to print solder paste on the test pad for easy ICT, because the probe can't reach the OSP covered pad.But to my surprise,after reflow there's much flux residue on top of test pad(or solder) an
Electronics Forum | Tue Sep 14 18:27:37 EDT 2004 | MikeF
I would need a little more information to be able to rule out some of the possible causes. Have you checked to see if the pins with the minimal solder have anything in common, do all have traces to them? or internal power or ground plane connections?
Electronics Forum | Tue Sep 28 17:56:02 EDT 2004 | Vee Sar
Adam, I would first check hole to lead sizes on the components that you are having hole fill issues with to see that the spacing is withing spec. Second, check for oxides on lead tips, and contaminated leads that cause poor wetting and insufficient
Electronics Forum | Tue Sep 14 08:46:31 EDT 2004 | scombs
I'm currently working for a OEM that has 700+ stencils in house and we received 30 to 40 stencil a month. We recently switched to a no clean process which is causing the stencil part numbers to disappear from the stencil frames due to the saponifier
Electronics Forum | Tue Sep 14 14:25:35 EDT 2004 | scombs
Thanks everyone for all the input. All of our stencils do have the PCB # etched on the foil but when operators look for the stencils they are looking for the part # on the frame since they are all stored vertically in a couple of Remstar shuttles and