Electronics Forum | Mon Feb 04 05:07:33 EST 2008 | mun4o
Hi, we have about 100L kester 108 - soldering flux thinner.That is thiner for Kester 2235 and some other fluxes.But we have not use this flux already, and I don't know what I can make with the tinner.Could you help me - what is chemical composition
Electronics Forum | Tue Feb 05 18:26:34 EST 2008 | janz
Hello, We have FCM base 2 machine (Philips-Assembelon). I am trying to find out whether it is possible to install instead vacuum pump (make noise and power consumption) venturi system. Does anyone try to do this.? What was the result.? What vent
Electronics Forum | Tue Feb 12 04:07:29 EST 2008 | aj
Hi, Have you checked out the BGA datasheet and see what profile is recommended for the BGA ? I use OM338 and there are dozens of recommended profiles for the Paste but you have to consider the components aswell. You state your Peak temp which I w
Electronics Forum | Fri Feb 22 12:02:24 EST 2008 | soudomphong
I have been searching for a compatible high temp chain oil other than Tribol 1421/SG due to cost cutting, which is what electrovert is recommending. I was wondering if anybody can tell me beside Tribol 1421/SG. What other brand out there that is come
Electronics Forum | Tue Mar 04 10:54:50 EST 2008 | vikkaraja
I think so,but what do you mean if hard drive is ok. Please explain.Computer boots up ok and machine even goes through it's complete intialization steps. I was thinking the same way as you are to start replacing one componet at a time. what do you th
Electronics Forum | Wed May 21 15:52:24 EDT 2008 | samir
Wow RealChunks! What happened to that firey b#tchey Asian temper of yours? :-) Speak your mind and forever hold your peace! Here's what I know about Lead-Free Wave Soldering: 1.) Hotter pot 2.) Longer dwells Good info. on fluxes, by the way.
Electronics Forum | Mon Jun 02 17:09:50 EDT 2008 | grics
Good Day! At our facility we are doing some research into becoming paperless in our manufacturing instructions. I was curious if anyone out there has had any luck in software other that Aegis or Valor. What kind of prices were the modules? What is
Electronics Forum | Wed Jul 02 15:41:41 EDT 2008 | patrickbruneel
Chunks, Thanks for covering my back. Except from being able to wave the big green flag what benefits does lead-free have? Once the green flag comes down we will see what a mess lead free has made. I hope that all the sales people that claim to mak
Electronics Forum | Wed Jul 16 10:15:53 EDT 2008 | chrno522
I would like to spend around US $30K - $50K, I've got an offer for EKRA E1 inline Semi Auto for $35K USD but EKRA can't fit the 29" stencil frame. Is this EKRA any good? What is the best machine to buy for my budget? any suggestions is greatly apprec
Electronics Forum | Wed Jul 30 16:57:23 EDT 2008 | stevek
Folks, I'm looking for some specs for the maximum bend or strain that should be put on a PWB. Not looking at the solderjoints. I'm concerned with localized bending of the fab and what might be a reasonable limit for that bending. I've measured 105
