Electronics Forum | Mon Apr 22 02:48:55 EDT 2002 | ianchan
Hi, a did a study on a FMEA for a government project, and I do not relish going thru that S**T again! Aye laddie, as a QA skirt i must protest! its called a kilt, not a skirt! *grinz* and we dun keep FMEAs in the folder cabinet, there's only room f
Electronics Forum | Fri Apr 19 12:39:10 EDT 2002 | Yannick
Hi Our compagny is in a high Mix, low quantit� production, We have so much trouble with the IC because the buyers don't wnat to pay to have the IC in a reel so we use a vibratory. Some operator are very good to make the vibratory work well but so
Electronics Forum | Wed Apr 24 13:23:37 EDT 2002 | gsmguru
Our design group is looking at using a IMPCB material for a power amplifier design. They would like to to use this because of it's excellent thermal properties. This would be used to create a "SIP" module that would plug into a std FR4 pcb with the c
Electronics Forum | Tue May 21 08:28:37 EDT 2002 | Johan Bergstrom
Many MYDATA customers might not be aware that some tapes are of PSA-type. They don't have to. In the early work with Agilis this was also an open issue for the design team, so several tests were made which showed that PSA would not be a problem. Rece
Electronics Forum | Mon May 06 02:30:25 EDT 2002 | dszeto
We have continual vision process error 1CB02003 on narrow view camera during nozzle centering measurement. The wide view camera works properly. So far we have done the following things to rectify the problem but the problem still exists: 1. Replac
Electronics Forum | Wed May 08 00:01:17 EDT 2002 | Bricia B. Grothaus
Hi there, I use to work in C & D Technologies (www.cdtechno.com) in Tucson, AZ as a Manufacturing Engineer. I was in charge of trainig employees on how to use the AOI system. It is very easy to use and maintain. The guys from CR Technology from
Electronics Forum | Fri May 10 14:02:05 EDT 2002 | pjc
First off what bone-head designer put them there in the first place. Vias in solder lands is a big time no no. I had this problem at a CEM I worked at. I had the customer change the design but had to run the 6 samples they supplied. I ended up fillin
Electronics Forum | Tue May 14 18:07:27 EDT 2002 | soupatech
My method is not good if accuracy is an issue. Most of our reels come with a guage on the back. It is not a perfect count but with a good eye you can get within a couple hundred on reels of 5k. On the reels shipped with no guage I usually just hold a
Electronics Forum | Thu May 16 15:05:20 EDT 2002 | Hussman69
No need to make rocket science out it. Buy an AOI mchine. If that's too expensive, scrap a board to use as a sample. Can't do that, use a digital camera and snap a couple pix of a good board and make some kick ass work instructions to use. Can't
Electronics Forum | Wed May 22 22:59:04 EDT 2002 | alex_kirichenko
Hello!!! Just to say, I've never even heard about placing parts on double-sided tape for inspection... We always build one board placing parts on paste/glue and inspect it befor reflow. With suppliers specs of 6hours at least, I don't see any prob