Electronics Forum | Tue Apr 29 12:07:37 EDT 2014 | rway
In my business, $150K is A LOT of money, mucho dinero. At these prices I expect the installation folks to have everything they need, or might need, to do the job. It's not my business to supply tools for an installation that we are paying for, or h
Electronics Forum | Fri Aug 29 22:55:51 EDT 2014 | andrespena
I'm very sorry I did not see this reply earlier. It's been almost a month and I hope you get to read this! I really like your idea of a *personal* electronic circuit factory. You should try getting schools to buy it, because students will love the o
Electronics Forum | Thu Jul 17 17:36:28 EDT 2014 | proy
Hi, > > If you can not rely on your programmer and > the tools he uses then "double checking" can save > you only materials but in time you really do not > save often extend meaning. There are things you > can identify before the stove, but if
Electronics Forum | Mon Aug 25 12:43:35 EDT 2014 | freddimock
Numerous people use the Pyramax oven to process high temp solder but your success will depend upon the mass of your board. To maximize the probability of success you should use the highest convection rate (IWC) possible to enhance heat transfer an
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Mon Oct 13 09:22:14 EDT 2014 | rgduval
Deni, Thanks. I managed to do pretty much exactly that. I was able to get the changers to pop up, and check the vacuum on the nozzles. The first two nozzles are very well sealed into the changer (can't move them), but, the balance of the nozzles
Electronics Forum | Wed Nov 19 18:51:22 EST 2014 | warwolf
your summary is pretty accurate! yeah our justification on the automatic system is long in the pipeline. we would need significant volume even then we could just bump the staff numbers. I can see how you are having troubles with the legacy requirem
Electronics Forum | Mon Feb 16 12:33:58 EST 2015 | ianatvadatech
Hey Syed, I've been running the MV-9 for just over a year. We shopped around very extensively (two APEX shows) before switching from yestech to mirtec and we bought two of the best systems they had to cover the four lines we run. Two systems are fa
Electronics Forum | Mon Mar 09 12:52:38 EDT 2015 | brianbrl
Hi, I had Assembleon machines for many years, and worked through a total of nine of them. Three years ago we began to look at the short-comings we had, based on the machines capabilities. We started to look for a new SMT platform that could improve
Electronics Forum | Tue May 05 11:05:53 EDT 2015 | billmeye
Brian, thank you for taking time to discuss your buying experience, I read your link and it was very thorough. I also work for a small CEM using Mydata equipment. We have had Mydata going back to 1998 but truely are looking for something simpler. F
.gif)
winsouce.jpg)