Electronics Forum | Fri Apr 27 13:04:35 EDT 2007 | rmitchell
Hi, I am having some problems with my Fuji CP6 placement repeatability. The placement drifts during the build about .06-.10 mm on parts. It has happened on several different builds this week. It is enough to cause some defects after reflow on smal
Electronics Forum | Wed Mar 19 15:59:40 EDT 2008 | rmitchell
Hi, I am having some problems with my CP6 placement changing in the Y axis. I had to move all parts by +.12mm this morning. Then after 20 boards the placement shifted too high by about .12 mm The IP stayed the same with the same pcb's and fid coo
Electronics Forum | Sat Aug 02 15:00:12 EDT 2008 | miroyu
I built aluminum cage add ground wire to it but my problem is not gone!Also , video is not in focus.How can I make it right.Does this shows that quadalign board is foulty? Any comments PLS? Thank you Miro
Electronics Forum | Fri Dec 10 02:49:06 EST 2010 | bagindia
we are facing vision error problem after running the machine for half an hour.Cause is x-axis motor % is changing & also motion is little harder compared with Y-axis
Electronics Forum | Thu Nov 03 01:39:53 EDT 2022 | spacecase
Thank you for the response, left the machine turned off for a good period of time and somehow the issue solved itself. I was able to calibrate the next day and homing hasn't been an issue. However now I'm having another problem where it gets 4 comple
Electronics Forum | Wed Feb 21 06:11:41 EST 2007 | CL
Good Morning, We have 5 Mydata MY machines in separate lines. We are placing 0201's, uBGA's, CSP's, etc.... I cant say that we have never had accuracy problems but whatever caused the problems was identified and they are fairly accurate as far as I'
Electronics Forum | Tue Aug 01 17:12:48 EDT 2006 | seth
My problem solved. I had to re-adjusted the reader,
Electronics Forum | Fri Sep 17 21:25:00 EDT 1999 | Rob
| | HI everyone, | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 an
Electronics Forum | Fri Sep 17 23:59:40 EDT 1999 | JAX
| | | HI everyone, | | | | | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00
Electronics Forum | Thu Mar 20 07:58:12 EDT 2008 | cyber_wolf
#1Run a Fuji gold board and see if the problem persist. Is your board clamp slipping? Fid camera tight? etc.. To see if you have a Y axis positioning problem: 1.Put the machine in mecha check 2.Go into Y-axis 3.Place a dial indicator so that the st
