Electronics Forum | Mon Jul 18 15:52:46 EDT 2022 | deonn
Hi, I am looking for a repair tech on reflow oven or SMT Equipment in Southwestern US region. Please forward any contact information and thank you. Deon deonnc@gmail.com
Electronics Forum | Tue Jul 19 13:58:38 EDT 2022 | proceng1
PRocedure is attached to post. I had calibration jigs made, but you can use a glass plate with a crosshair, or a hole in the board.
Electronics Forum | Tue Jul 19 16:15:10 EDT 2022 | proceng1
great. If you need anymore help, let me know. At one point I had four of the MACH3 machines. I still have 1 that doesn't get used much, but I have two SWAK machines now.
Electronics Forum | Sat Jul 23 12:41:26 EDT 2022 | madisreivik
If you need to cut longer lengths and chip clogging / evacuation / edge finish is problem, then contact me privately, we have an unique solution for that.
Electronics Forum | Tue Jul 26 13:04:02 EDT 2022 | kumarb
Hi. Sharing a new contact we have from a company in Shenzhen that has a focus on refurb machines that may be worth a quick call: www.qy-smt.com smtripathy[at]qy-smt.com They apparently setup up shops even on a rental basis! Unbelievable that they w
Electronics Forum | Tue Jul 26 19:07:30 EDT 2022 | nextgen
Thank you for your input Austin. That is exactly what happened. When I replaced the mixed bed, the smell stop.
Electronics Forum | Wed Jul 27 17:26:55 EDT 2022 | proceng1
I'm having trouble picturing your setup, but can you put kapton on the columns? Or heat shrink tubing?
Electronics Forum | Mon Aug 01 19:43:08 EDT 2022 | emeto
I would assume it can do under some conditions. If you manually go and define pick up positions for all parts, may be there is not a good distance between two parts to pick at the same time. There also might be ON/OFF menu for this option.
Electronics Forum | Wed Aug 03 07:05:46 EDT 2022 | klauss
I got special nozzles, too. but i think i recognize them wrong into the program. Do you please tell me what's the recommended vacuum break time, placement condition keeping time and placement speed
Electronics Forum | Wed Aug 03 14:09:57 EDT 2022 | emeto
1. Add controls in programming and setup creation for polarity 2. Check polarities in actual setup before you run. They should match the paper.