Tamura Tamura spray fluxer
Model: |
Tamura Tamura spray fluxer |
Category: |
|
Model Year: |
2005 |
Condition: |
|
Value: |
$ 10000.00 |
Location: |
California, USA |
Offered by: |
|
Contact Supplier |
Spray-on Fluxer Device
TAF40-12V, TAF40-15PV
This is an automatic spray device to apply the
post-flux: It is used in order to better soldering
effect when you use the Wave Soldering
Device (below). You can change the amount
of the post-flux quite flexibly according to the
condition.
Since the latent heat of vaporization of low-VOC flux is higher than
IPA, securing a uniform and effective coating had been a
technical challenge for the development of spray fluxers. In
collaboration with Tamura FA System, we have overcome these
issues. The most outstanding feature of the spray fluxer lies in the
fact that the distribution of particle size spray is homogeneous and
very fine.
The most important constituent to the soldering using post flux is
the activator. For proper soldering performance, an appropriate
amount of activator needs to be applied to the right position.
The solvent currently used for post flux is alcohol-based (mostly
IPA) as it uniformly dissolves activators and resin. The following
requirements need to be satisfied to reduce the VOC from the
solvent.