Electronics Forum | Fri Jan 21 19:30:11 EST 2005 | Dreamsniper
Hi T2, The purpose of this is that we want to make our rework robust. Whenever we rework BGA's we have solder getting trapped into those 1 sided tented vias and bet yah...they are hard to desolder! And during BGA resoldering these trapped solder will
Electronics Forum | Tue Mar 22 20:33:24 EST 2005 | davef
Q1. What are you guys doing for filled/tented/plugged vias on the BGA site? A2. 2221A, 4.5.1 tells you the vias have to be tented on both sides. Q2. What type of issues can this cause if using no filled/tented/plugged vias on the BGA site? A2. BGA
Electronics Forum | Fri Jun 09 17:34:08 EDT 2000 | Melanie Mulcahy
I need some information regarding the acceptability/unacceptability of using tented vias with LPI soldermask. Long story on all involved, but basically I have a board that I have had manufactured with no problems which has BGA/uBGA parts, tented via
Electronics Forum | Tue Mar 22 08:05:59 EST 2005 | jdumont
Morning all, my question is regarding the use of filled/tented/plugged vias on the BGA site. What are you guys doing for this? What type of issues can this cause if using none, or the improper via design. Regards, JD
Electronics Forum | Fri Jan 21 16:50:33 EST 2005 | Board House
I work for a board house and our proceedure for this process is the following, We cover the via pads leaving the hole open and then apply the surface finish and then go back and Cover the Via with a second operation. By doing this you do not entrap
Electronics Forum | Sun Jan 09 19:37:15 EST 2005 | Bob R.
I'm just thinking out loud here with no experience to back it up, but I could see where you're trapping air or solvent filled voids inside the via by tenting from both sides. When you go through a heat cycle like reflow or wave solder you could be e
Electronics Forum | Wed Feb 16 09:33:09 EST 2000 | Kurt Waskow
Interested in information regarding PCB soldermask tenting over vias within a BGA layout. Is this a common practice to reduce the occurrence of shorts, are there any reliability concerns? Thanks!
Electronics Forum | Mon Feb 21 08:33:53 EST 2000 | Tony Di Mauro
Kurt, When I was working in a captive manufacturing house we had been to migrate toward tenting all vias under the BGA to eliminate not only shorts but insufficient (Starved) joints. Tony
Electronics Forum | Wed Feb 16 09:33:09 EST 2000 | Kurt Waskow
Interested in information regarding PCB soldermask tenting over vias within a BGA layout. Is this a common practice to reduce the occurrence of shorts, are there any reliability concerns? Thanks!
Electronics Forum | Mon Feb 21 08:33:53 EST 2000 | Tony Di Mauro
Kurt, When I was working in a captive manufacturing house we had been to migrate toward tenting all vias under the BGA to eliminate not only shorts but insufficient (Starved) joints. Tony
.png)
