Industry News | 2021-11-30 01:54:12.0
After more than 100 years of development, X-ray imaging technology has formed a relatively complete X-ray non-destructive testing (NDT) technology system. In order to meet these needs, new detection technologies are constantly innovating, using Xray inline inspection technology. It can not only detect invisible crack or porosity such as aluminum casting , but also qualitatively and quantitatively analyze the detection results to find flaws early.
Industry News | 2021-12-27 20:26:21.0
When speaking of air conditioners, everyone is familiar with them. Especially in the hot summer, we would not know how to live without it. But when it comes to refrigeration compressors, many consumers are not particularly clear. In fact, the refrigeration compressor is an important part of air conditioners and refrigerators, and its performance and quality directly determine the cooling effect of them. The following is an introduction to the types of refrigeration compressors.
Industry News | 2013-12-05 07:59:46.0
Ucamco is delighted to present its ground-breaking second extension for the Gerber format. This offers an unequivocal standard for non-image data that is just as simple, practical and universally accessible as the well-known Gerber image data format it now supports.
Industry News | 2014-01-24 16:51:33.0
At Southern Manufacturing 2014 AdoptSMT UK Ltd., member of AdoptSMT Group, will again present many new products for the European PCB Assembly Industry. The supplies, services and consultancy offered by AdoptSMT Group are focused around the aim to keep the customers production running.
Industry News | 2019-11-05 22:07:01.0
Tenting a via refers to covering via with soldermask to enclose or skin over the opening. A via is a hole drilled into the PCB that allows multiple layers on the PCB to be connected to each other. A non tented via is just a via that is not covered with the soldermask layer. Leaving these vias exposed or covered has pros and cons depending on the your design and manufacturing requirements.
Industry News | 2003-05-27 08:20:51.0
Extends from high-level FPGA design through Printed Circuit Board (PCB) design
Electronics Forum | Wed Jul 24 10:12:48 EDT 2002 | jax
Claude, Are you saying this is how ya'll handle the issue???
Electronics Forum | Wed Jul 24 07:18:12 EDT 2002 | lloyd
Hi, We occasionaly have problems with some of our panellised boards breaking away from each other. The section joining them is very small and makes the assembly weak. The boards are normally broken off during our through hole process (bad handling)
Electronics Forum | Wed Jul 24 16:36:53 EDT 2002 | russ
If you have a board router then I would reccomend an epoxy to re-attach the boards. If not try a high temp loctite russ