Electronics Forum | Mon Jan 15 08:54:40 EST 2024 | SMTA-64304553
Trying to understand the impact of iron contamination above IPC recommendations (0.02%) on selective solder joints. Brittleness and discolouration are known but are there other factors that should be accounted for?
Electronics Forum | Wed Mar 12 16:30:45 EDT 2008 | operator
I witnessed this at our sister company. It seems to be their standard process. It is not my place to interfere with their processes. I was just curious if there was any chance of brittle solder joints or other defects that might be caused from the WS
Electronics Forum | Fri May 03 16:06:44 EDT 2013 | hegemon
To be short, no change in profile is going to get you through this. As I recall the point of hard gold is to retard the wetting process, so no surprise here. For example a connector might have hard gold plating at the mating surface, but not at t
Electronics Forum | Mon Apr 16 11:58:07 EDT 2007 | cingsman
I believe SAC305 will result in a lesser amount of Ag3Sn inter-metallic compounds being formed along the joint boundary and in the sphere. Studies have been shown to point out a significant difference between the number and size of Ag3Sn plates in SA
Electronics Forum | Fri May 24 09:16:36 EDT 2013 | grahamcooper22
you need to reduce your time above liquidus to as low as you can...maybe 10~30 secs to allow the solder to wet to the gold but minimise the amount of gold that is dissolved into the solder joint...try also reducing the peak temp to 200~210 deg C. Thi
Electronics Forum | Mon Jul 01 15:37:56 EDT 2002 | pjc
Possible cause can be design related- if the solder land is too small. Check w/ IPC SM-782 Solder Land Design Guide Another is board finish. I have seen problems like this with Gold finished PWBs- which creates a more brittle solder joint.Another pos
Electronics Forum | Wed Feb 25 17:02:05 EST 1998 | Doug Romm
Just a comment to clarify this discussion. Typically chip caps and other passive components that use palladium plated to the end of the component are very different from the TI nickel/palladium plated IC components (leaded devices). The main di
Electronics Forum | Wed Jun 07 11:25:23 EDT 2000 | Dave F
In the portion of Chapter 1 on Flip Chips, Ken Gallio states (1.8.2.1) "tin/lead solder leaching or dissolving gold and form metal compounds, called dendrites, that greatly reduce joint reliability because of high brittleness." What is the compositi
Electronics Forum | Tue Apr 17 09:54:49 EDT 2007 | patrickbruneel
The only way to resolve these issues is to bring back the good ol� lead and make the joints ductile instead of brittle for an affordable price. Thanks for the link Dave
Electronics Forum | Tue Jun 19 19:03:31 EDT 2007 | diesel_1t
Hi folks. If the solder is on the BGA but is not soldered at all on the pads, then you can discard BGA solder issues, by the other hand; you might be experiencing wicking due to heat is being absorbed on component so the balls on BGA are hotter than
