Electronics Forum | Tue Jul 17 09:10:28 EDT 2012 | dontfeedphils
You can enter the service program for the MyData, can't remember exactly how, you have to exit out of tpsys to the command prompt and type service or something along those lines. Then you can check the raw numbers for vacuum and force on the Midas h
Electronics Forum | Tue May 07 13:41:36 EDT 2013 | cyber_wolf
MOVFI is a theta error there are about 10 things that can cause it. Start with making sure you do not have an acceleration set to lowest while the others are at high or highest in the package data. Next look at ribbon cables...
Electronics Forum | Wed Jan 17 15:07:34 EST 2024 | rmrshield
BIRAL is a HEAD cleaning oil it's not a overall HEAD clean the inside of nozele picker only
Electronics Forum | Fri Jan 26 16:38:15 EST 2024 | mistrthou
Do you get any errors during the tool install? Are you intalling all tools, all uninstalled tools? What if you try one single tool only (A12)?
Electronics Forum | Fri Jan 05 17:27:46 EST 2024 | rmrshield
Please clean the HEAD in BIRAL and put the NYK-2 Greese Solved thit issue
Electronics Forum | Wed Dec 04 16:35:54 EST 2013 | martingruber
I am facing the following problem: Powering up the machine the start sequence stops with following message: Inizializing Hardware .... Reading SRAM data .... Inizializing MEI Motion Bd .... Mei bd. @ 240 # Dev. Version 2.4g2 Option 41 DSP BOOT MEMORY
Electronics Forum | Wed May 11 20:25:38 EDT 2022 | mikevb
Thanks. Yes, I replaced the ffx board with a new one and made sure everything is cleaned. I did check the flex cable connect as I removed all of that to test continuity between everything. It all checked out continuity wise. I also tried to disable t
Electronics Forum | Wed May 04 19:38:57 EDT 2022 | mikevb
I have a used MyData My9 machine that I've picked up recently and it has a problem with initializing that I can't figure out. It just gives an error stating "no z indicator value at all". I've replaced the flex board with the force sensors but that d
Electronics Forum | Mon Oct 25 11:20:52 EDT 2021 | bk
The 245 error is with your x belt motor not the x wagon motor. double check all the fuses on the back of the machine where your power comes in there should be 3 of them. if you haven't changed your blue cables in a while I would change those out. you
Electronics Forum | Mon Apr 08 00:06:58 EDT 2013 | toddmahon
Have you had any luck? I just purchased the same machine and it has some kind of a boot error. After power up a screen pops up in Japanese with English sub titles. In the bottom left corner it reads Memory Card Data Error - Load Data. I connected to
