Electronics Forum | Tue Mar 20 15:55:59 EST 2001 | CAL
I only inhale flux with a high IPA content.(joke for those who don't know me) I have seen the inside of duct work for our wave soldering machine............NASTY! DAVE F. is right! Flux contains a lot of bad stuff- Chlorides, Bromides, Flourides,
Electronics Forum | Tue Dec 22 10:00:31 EST 1998 | Chrys
| | | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | | Good or bad for high volume Thrue Hole? | | | | | | Thanks Again, | | | Brian Steelg
Electronics Forum | Mon Oct 22 15:41:39 EDT 2007 | davef
Bruno The real question about your troop using Kester 951 wave solder flux on boards is: how is the flux applied and controlled. See, when you apply this flux with your wave solder fluxer, it is ideally applied in a metered fashion with your fluxer
Electronics Forum | Wed May 06 08:15:39 EDT 2009 | xinxi
Hi all, I understand that this forum is more to surface mount discussion. But I am eager in sorting out the spray fluxer problem. Please provide me with any ideas that you think might cause it. I have a problem in starting up/initialising the wave
Electronics Forum | Tue Dec 01 13:53:12 EST 1998 | Brian Conner
| | | | | | All y'll: I could use your input on determining when to skim dross from a wave solder pot. | | | | | | | | | | | | On one hand, dross protects the surface of the solder from oxidation. On the other hand too much dross may affect solder
Electronics Forum | Wed Dec 02 09:03:34 EST 1998 | Dave F
| | | | | | | All y'll: I could use your input on determining when to skim dross from a wave solder pot. | | | | | | | | | | | | | | On one hand, dross protects the surface of the solder from oxidation. On the other hand too much dross may affect
Electronics Forum | Thu Mar 08 03:13:20 EST 2018 | rob
Don't go down that route, Juki cut spares support a few years ago on these. Although bits are available from China, you do not want to be swapping used cards. They are both also dog slow in real life whatever you do to them. Especially a 760. We'r
Electronics Forum | Tue Dec 01 12:44:15 EST 1998 | Earl Moon
| | | | | All y'll: I could use your input on determining when to skim dross from a wave solder pot. | | | | | | | | | | On one hand, dross protects the surface of the solder from oxidation. On the other hand too much dross may affect solder joint
Electronics Forum | Tue Apr 18 06:15:49 EDT 2006 | JH
AJ, I have had the Solder Saver on trial a couple of times and reached the same conclusion both times - it is not for us. However there are benifits for some users. In case you dont know how it works, here is a brief explanation; The hand held to
Electronics Forum | Thu Jan 28 10:09:51 EST 1999 | Charles Stringer
| | | | Greetings, | | | | | | | | Can anyone tell me what temperatures pcb's should have when coming out of a forced convection reflow oven and out of a wavesoldering machine. | | | | Also, is there any danger of the pcb's giving off some kind of g
