S & B CONTROLS 38111500500000 TEMP.CONTROLLER S & B CONTROLS 38111501401110 TEMP.CONTROLLER S & B CONTROLS PRCQ1-00-1000 TEMP.CONTROLLER S & B CONTROLS RCQ4-00-2222-08 DIGITEMP MC S & B CONTROLS RCQ4-21-2222-08 DIGITEMP MC S & B C
New Equipment | Industrial Automation
XC08L1 XK08F1 XO16N1 XM06B5 XE08B5 AC31GRAF 07SK50 CP410M CP415M CP420B CP430B CP430BP CP430BP-ETH CP430T CP430T-ETH CP435T PM554-T CP435T-ETH CP440C-ETH CP450T CP450T-ETH TK401 TK403 TK405 TA562-RS-RTC DNC11-FBP.999 DNR11-FBP.120 XK08F1 XC08L1 XO16N
Electronics Forum | Thu Jul 27 16:54:46 EDT 2006 | pjc
In-Circuit test, or ICT, is the most common method of electrical test for an assembled PCB. It is the most comprehensive and accurate method to ensure that both the PWB and components are working to specification. Not all components however can be el
Electronics Forum | Wed Mar 10 12:02:07 EST 1999 | Craig Holloway
Looking for advice/products on ways to get heat out of a package and into an internal thermal plane. Will have electrically isolated thermal pads (going to an internal thermal plane) under the part. Need a way to get good thermal contact between par
Electronics Forum | Thu Mar 11 11:58:18 EST 1999 | P.L. Sorenson - Technical Consultant
| Looking for advice/products on ways to get heat out of a package and into an internal thermal plane. Will have electrically isolated thermal pads (going to an internal thermal plane) under the part. | | Need a way to get good thermal contact betwe
Electronics Forum | Thu Jan 25 09:45:54 EST 2007 | SWAG
You might consider installing a noise kit as it sounds like you've tried almost everything else. Electrical interference on these machines causes erratic problems, especially as they get older. I would call Speedline tech. and see if they think the
Electronics Forum | Tue Jun 22 17:14:41 EDT 1999 | Dennis Fall
I am looking to apply 10-15�m of a conductive material that will withstand 280�C. Our product consists of an alumina substrate sputtered with NiCr (2000�) and Copper (2000�) and 15-60 �m of electroplated copper (all metals patterned on the substrae)
Electronics Forum | Wed Jun 23 10:21:25 EDT 1999 | Chrys Shea
| I am looking to apply 10-15�m of a conductive material that will withstand 280�C. Our product consists of an alumina substrate sputtered with NiCr (2000�) and Copper (2000�) and 15-60 �m of electroplated copper (all metals patterned on the substra
Electronics Forum | Thu Aug 10 10:13:11 EDT 2006 | pjc
I have never seen any industry standards for setting up an SMT assembly facility, but I�ll offer some basic advise. An ideal SMT assembly facility is one that is clean and well lit and has environmental controls to maintain temp and RH. Temp of 24C (
Electronics Forum | Mon Nov 07 19:33:10 EST 2011 | swag
We have four pick and place machines all exibiting a residue that seems to build up over time on wiring and electrical components. This residue appears as a white haze on wiring, caps and fuses (these are the components where it is most obvious). Y