Electronics Forum | Mon Jul 10 13:08:21 EDT 2023 | ttheis
Thanks, I do recall reading about loading firmware onto some of the VME cards (VRM axis controllers I believe.) I will review this again. I agree that it seems to be some issue with reading axis position after hitting the home switch. The first thin
Electronics Forum | Wed Apr 20 13:13:20 EDT 2016 | ttheis
Hi Guys, Yesterday one of our two gsm1 machines just stopped moving and let down the board mid-production. The epc computer continued to respond but no messages were displayed when palming up or down. I tried local IO and it said no IO was configure
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Thu Dec 31 19:25:11 EST 2015 | ttheis
Resolved. Thanks to some information provided by the fine folks over at Capital Equipment Exchange I was able to update the system to a EXP-VID-B video card, replacing the EXM-13A and EXM-14 combination. This update eliminates the jumper cable betwe
Electronics Forum | Wed Dec 09 11:24:45 EST 2015 | ttheis
Thank you, Tushar, for the information and for the phone call; it is very kind of you to share your knowledge. I appreciate the advice to back up our machine configuration, mapping and calibration files. I installed the card in slot 2 per your docu
Electronics Forum | Fri Sep 27 15:14:04 EDT 2019 | dilogic
Just one more thought - we had an issue with +12V supply for VME rack. One tantalum cap in the DC/DC converter module for linear encoder interpolator shorted it out, but oddly enough - not always. We ended up hooking scope to all PSU voltages and whe
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Mon Oct 20 10:08:42 EDT 2014 | rgduval
Had someone in from the broker that we bought this machine from, and he did some poking around. We've learned some things, but, unfortunately, are still no closer to getting the machine running :( We discovered (based on double checking other machi
Career Center | Melbourne, Florida USA | Engineering
I have over 24 years experience in the PCB manufacturing arena. My career knowledge is in most SMT manufacturing equipment. Creating and troubleshooting manufacturing assembly processes and creating detailed work instructions using Microsoft Power