Electronics Forum | Thu Jul 20 11:18:43 EDT 2006 | ev
Paul, the error says "MOT1-38-247 MSETDYNX: Xwagon fan not working." I have checked...the X motor fan and it is working...the fan behind the PAIB board is also working...I checked this because there is a connector marked X wagon fan on the PAIB boa
Electronics Forum | Mon Dec 07 09:43:09 EST 2009 | kpm135
Just to throw my two cents in the MY19 could be slower than the other my machines due to the greater distance the head has to travel to pick up and place the components.The longer distance could also account for extra wear and tear on the motors and
Electronics Forum | Tue Nov 13 11:14:15 EST 2012 | jaimebc
For the past few weeks we have experienced an intermitent midas theta error.During normal production the machine times out while just after picking up a component waiting for the theta to center it.Sometimes it fails to leave a tool. Reinitianing the
Electronics Forum | Tue Mar 17 12:48:41 EDT 2015 | cyber_wolf
Couple things: If the rubber roller that touches the take up wheels is worn you can adjust it. The axle is on an eccentric. Make sure the "teddy bear faces" that adjust the pick point are not grossly different from the left to right sides of the ma
Electronics Forum | Fri Feb 21 10:50:00 EST 2020 | tomdegas
I am getting the following error on our MY9 during hardware initialization: F-MOT-MSEDYN HYDRA Z/156 Motor Timeout After the Theta test, The HYDRA head moves slowly all the way to the bottom and then moves slowly back up and the system fails initia
Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Sat May 29 15:58:37 EDT 2004 | Patrick Tarell ... Automation Engineering Jabil Circuit
Hello Alan! We have used both chipshooters, we also have a Mydata with the hydra head... We switched entirely from Fuji CP7 to the UIC HSP4796 and now HSP4797. The CP7 is a nice machine but we were very unhappy with the support structure within Fu
Electronics Forum | Wed Apr 15 14:51:52 EDT 2009 | cyber_wolf
The booster was swapped. I found that I have -35 volts across pins 1 and 3 on the XWB.(measured with a scope) When I switch polarity in the software I do not get anything.(no +35V) I noticed that when I try to pulse the small X with the scope hooked
Electronics Forum | Mon Oct 05 08:19:13 EDT 2009 | rgduval
We've been having random transducer errors on our TP recently. After speaking with MyData tech support, we were told the answer could be: 1. the transducer(s), 2. something causing undue friction, 3. something undiagonsed yet. Their recomendation
Electronics Forum | Mon Oct 05 10:29:38 EDT 2009 | cyber_wolf
I ended up finding that there were broken chords on the X-belt. I replaced it and all is good. Rob, Mydata is right. You can indeed end up spending lots of time and money trying to chase a transducer error. Things I would look at: 1. Lubing the X b
