Electronics Forum | Sat Feb 10 10:08:04 EST 2018 | griinder
We recently acquired used MPM Accuflex. Immediately I noticed the live vision is mirrored. This makes it incredibly difficult to teach fiducials. I noticed some smudges on the lens, which leads me to believe the camera assembly was "worked on" at som
Electronics Forum | Thu Feb 25 06:59:04 EST 2010 | ristikas
Probably the ribbon cable are broken. I had same issue some time ago. Cable connected to camera and placed under cover. Spare part code is 1007867.
Electronics Forum | Mon Mar 15 18:03:21 EDT 2010 | smt_guy
hi, check the home sensors if they are working specially on the right side rail of the camera where you had the failure.
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Thu Aug 13 14:52:42 EDT 2015 | deanott
We just encountered a problem with the vision on our MPM Accuflex. We just switched jobs and when we went through a 'Vision Set-up' there was no image (just blank gray screen where you'd normally see the PCB or bottom of stencil). When we tried to
Electronics Forum | Tue Mar 06 06:58:29 EST 2018 | griinder
Thank you guys for your help and detailed explanations. I have successfully been able to teach pads as fids. The camera view is very annoying, but manageable. Especially when teaching inspection positions. On the momentum's we can use Gerber EZ Teac
Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Tue Mar 02 04:30:32 EST 2010 | sigmaprint
Hi. It sounds like you may have the problem under control as you have ordered parts but if it still doesn't work please don't hesitate to contact us at sales@accuspares.com or visit our website http://www.accuspares.com. We should be able to help....
Electronics Forum | Tue Mar 02 03:41:13 EST 2010 | ristikas
Unfortunately i am not a seller. I am ordering the part from sincotron.eu I dont know your location but if you are in EU then contact them.
Electronics Forum | Mon Aug 17 11:29:41 EDT 2015 | deanott
Thanks for the useful instruction. We did find a loose connection. It was the connector right at the camera/PCB. I believe it was bumped when placing board supports (going forward we'll move the camera to the rear when placing board supports).
