Electronics Forum | Sat Jun 25 15:20:03 EDT 2016 | skipper6567
I have a mini/micro transformer that is mounted on a pcb inside my lowrance gps/plotter. I have removed it from the pcb. It has 5 through hole pins, 3 pins out bottom one side and 2 pins out bottom on opposite side. The transformer has yellow tape ar
Electronics Forum | Wed Apr 07 11:21:26 EDT 2004 | stefwitt
Hi Dilbert, it is a step up transformer from 3 phase 208 to 3 phase 380. Each machine does not draw more than 3 Amps per phase. However, circuit breakers are rated at 15 Amps. The transformer has three power outlets, each one has a Perilex (European)
Electronics Forum | Tue Apr 11 10:30:46 EDT 2000 | Jeremy Smith
I am having a problem with some joints on a 100 pin pqfp and few different soics on one particular board. When viewed a 8x with a "Mantis" inspection scope the joints look as though they wetted to the ic leg but when probed the leg will pop loose.
Electronics Forum | Fri Nov 18 12:35:15 EST 2011 | rway
As the article eludes to, you still need probe access to measure the pins with TestJet. One thing I wanted to add was the use of JTAG for use with Boundary Scan. Certain devices have JTAG capability, but not all JTAG devices are Boundary Scan compa
Electronics Forum | Sat Feb 17 14:21:54 EST 2007 | Muhammad Haris
Hi All, I am using YV100Xg YAMAHA Pick and Place Mounter Machine and I am facing a tilting problem of PLCC 84 and QFP 240 pins ICs. I deeply checked about their vision files and place them on the double sided tape and found them ACCURATE on their pad
Electronics Forum | Wed Jul 14 16:59:52 EDT 2010 | swag
Solder paste on the pads will keep part aligned. If you do not use paste, you will need to apply tacky flux. You should not run without one or the other.
Electronics Forum | Tue Mar 09 18:21:37 EST 1999 | Stan Levitsky
We will wave solder a board with SOIC14 and SOIC16 parts on the bottom. It has been difficult to find any specific wave solder process recommendations from manufacturers of the SOICs. The pad geometry utilizes theiving pads on both sides to reduce br