Electronics Forum | Tue May 08 15:00:26 EDT 2012 | jorge_quijano
Hello guys, I have a error message in a QSV-1 machine, when it tuns on "File archive error occurred while reading header of table top:permanent table top", I have no experience with this machine, so no good so far, already escalated to service and wa
Electronics Forum | Fri May 09 05:09:41 EDT 2014 | col_d
We're having an intermittent fault with a QSV-1 where it will on occasions oscillate violently during a run and this usually results in 1 or both Z-rods being destroyed, along with the nozzle currently fitted. This has been on and off for the last 2
Electronics Forum | Tue Jun 26 15:27:14 EDT 2018 | Dex
Why would we change? our fuji equipment was previously owned by Motorola and have many hours on them. we struggle to place 0402 components and the vision system on the CP seems to be one foot in the grave. The machines are tired and have been ran har
Electronics Forum | Fri Jul 19 06:52:34 EDT 2013 | deanm
A Quad QSV-1 can do up to 18x24in. You can get these on the used market or buy a completely refurbished (like new) machine from Precision Placement Machines (PPM). I do not represent this company or am in any way affiliated with them, although they d
Electronics Forum | Wed Aug 01 01:35:22 EDT 2001 | DL
Jay, I agree with your assement and Chips on the Quads. I once worked at a shop that had Quads and DynaPerts(at the time) The perts were slower(TIME) and required(EFFORT/PEOPLE) more MAINTENANCE(more effort more people and more requirements!!!). I'v
Electronics Forum | Mon May 19 15:42:37 EDT 2008 | torch
hey folks, just finished a quick 4 day training course on our 2nd user Quad QSV-1 and will probably have more questions later on but for now can someone confirm that qsoft needs its theta data in + numbers and cannot handle - theta figures? what i m
Electronics Forum | Thu Jun 14 20:54:57 EDT 2012 | deanm
We have a Quad QSV-1 and have had some trouble with it reading 0.040" fiducials. Our work is very low volume so we just manually spot the ones it can't read. We do not clean the fiducials. Instead we increased the fiducial size to 0.060" and it has b
Electronics Forum | Tue Nov 25 08:36:32 EST 2014 | bobpan
Tep stands for the transport card. The board is located in the front bottom left of the machine and should be by itself and have green and red leds lit on the top of it. I would try to reseat the card and then try to reboot the machine. If the proble
Electronics Forum | Thu Jul 25 14:18:34 EDT 2019 | babe7362000
It's been awhile but I was wondering if anyone knows how to read the LED's on the Tep board to what they mean. Top 4 Red 1. blinking red 2. lit red 3. off 4. lit red 5. lit red 1. blinking green 2. not lit 3. lit green 4. off 5. off On the Gui
Electronics Forum | Mon Jan 20 03:50:37 EST 2020 | falconex_technician
Hi, my company bough second hand pick and place as our second machine. After first transport after start just when initializing, It's showing problem with Z calibration. After second position setup and connect again after month, now showing &
