Electronics Forum | Tue Aug 29 21:14:45 EDT 2006 | Bubba
You need a machine with side clamps. DEK makes them. MPM makes them. Look into a retro for your machine. Both take up space on top of your board. Be carefull of top side component clerance if switching.
Electronics Forum | Mon Apr 28 21:51:56 EDT 2014 | elabcircuits
Hello, We have a MPM UP2000 HiE printer from 2000, software version 7.2E. The PC board is not booting anymore (black screen), no drives spinning. It's an Advantech 486SX version. Question: would a Pentium 3 SBC (Single Board Computer) with ISA
Electronics Forum | Fri Oct 29 15:29:56 EDT 2004 | jasont
Hi Ran, Have you considered 2nd hand screen printers? We are an SMT equipment re-seller but also operate a subsidary CM factory in SuZhou, China . We use Dek 265 LT and MPM AP screen printers in our SuZhou factory and have the following in stock f
Electronics Forum | Mon Sep 04 16:07:38 EDT 2006 | C.K.
Grid Loks & Gels ain't my forte, but when it comes to JNJ Support Plates for the MPM, (http://www.jnj-ndustries.com/PDFFiles/Techno%20Talk/Vol.%20VI%20-%20WEB%202003.pdf) and Quantum Physics....I'm your man.
Electronics Forum | Thu Aug 13 19:51:47 EDT 2009 | prasadz
Jagadeesh Rajagopalan is the expert in MPM Screen printer Servicing and he suggest to do the calibration of Z axis with PCB thickness (1.3mm)
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Thu May 24 12:56:31 EDT 2007 | adlsmt
Im sure you will get some better responses but here is a start. We went from UP2000 to UP3000 Ultraflex about 2 years ago. The UP-2000 uses tooling nests and UP-3000 Ultraflex does not. Makes a huge difference in setup time. Up-3000 is BIG. I think t
Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Wed May 15 15:55:52 EDT 2002 | swagner
The Dek Infinity will cost you anywhere from $170-$210k dependant on option, I.E. gold camera, form flex support tooling, proflow printhead, paste inspection and aperature inspection all drive the cost of this machine. The only MPM I have quoted lat
Electronics Forum | Wed Mar 30 17:58:18 EDT 2022 | proceng1
I think I have UP1500 SW. Not sure if it's the same. I also have Accuflex SW, which is pretty similar to UP1500
.jpg)