Electronics Forum | Fri May 15 15:09:03 EDT 2009 | pcbrookie
We recently added a 7-zone Heller, and have had a 5-zone Heller for quite some time. When the tech installed our new oven, we were told the new oven does NOT have the lifetime warranty on heaters and blowers. However, when we order parts for the ol
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
Electronics Forum | Fri Jun 03 09:00:06 EDT 2005 | russ
How many times have you found that your oven was performing differently? this will give you the answer on frequency. We have a dedicated board and profile that we use to verify the oven operation. We perform this every 3 mos. and I believe that th
Electronics Forum | Tue Jan 31 17:18:37 EST 2017 | mainenetservices
You can contact Heller service by email info@hellerindustries.com to get help with any issue. High Deviation or high process alarm could be due to one of the below reason. A. Blower motor in subject zone is not running – check for air flow B. Heat
Electronics Forum | Mon Mar 11 07:58:59 EDT 2013 | cyber_wolf
So I have this issue with my 1240. During my weekly oven surveyor check I get a software alarm that says I am out of tolerance. Probe #3 which is closest to the hinge side of the oven is approx. 10 degrees hotter in zone 12 than the other 2 probes o
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Career Center | new delhi, India | Engineering,Technical Support
Dear Sir/Madam, I would like to take this opportunity of introducing myself to you. I am Software Developer. Presently I am working with Autometers Alliance Ltd. and looking for a better option that gives me a platform where I can utilize my techni
