Electronics Forum | Thu Aug 27 03:19:21 EDT 2020 | dekhead
Have you done Squeegee Heights calibration? (no tools required) Does it complete cal routine without error? Does pressure compensate on next print, with corresponding squeegee, following acknowledgement of pressure error? The readings calibration, ge
Electronics Forum | Fri Jun 22 20:46:10 EDT 2007 | nickh
I ran into an error with our DEK 288 machine, when I go to initialize the machine the following error occurs: Squeegee Height: Error Input Active. This occurs with or without a squeegee present, and I have tried restarting multiple times, but the sa
Electronics Forum | Wed Feb 23 22:56:46 EST 2011 | jeffr
When I enter the "Setup Table Contact" menu, then press "Load PCB" the squeegee head should move to a mid position that I can set the squeegee height, but instead it moves the squeegee head to the front limit and displays a red error message about th
Electronics Forum | Wed Apr 28 09:43:22 EDT 2004 | Rob
When it comes to double-sided boards, how does one support a board so that those supports don't hit any components on the side already run but yet keep the board firm and rigid? Is it more of an engineering design to layout the board in such a way th
Electronics Forum | Mon Aug 02 08:52:57 EDT 2010 | vetteboy86
I can't say that I have an answer as to fixing the mechanics of your issue. However, doesn't that machine have an auto blade height? If so, even with one blade lower than the other, the blade height should only depend on stencil height. I could be co
Electronics Forum | Mon Aug 02 08:58:43 EDT 2010 | kpm135
It's been a while but I believe the UP2000's should have a calibration for the squeegee height as well. I think you log in under the Calibrate or Maintenance then that should give you access to the menu you need. Once you find it I'm pretty sure it w
Electronics Forum | Wed Aug 22 09:53:06 EDT 2007 | slthomas
"The question is: should we be looking at the operator? the paste? or the setup?" Yes. ;) Those guys love to brag about their 4 corner height adjustment on those printers. The fact is it's a PITA and shouldn't be necessary in the first place. It's
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Thu Feb 11 09:45:06 EST 1999 | Dave F
| | | Helo, | | Is it common for actual print height of solder paste to exceed the stencil thickness. For example If the stencil is 6mill thick and the actual height of the print is apx. 10 or 11mill. What causes the paste height to be greater t
Electronics Forum | Tue Aug 01 19:52:19 EDT 2006 | darby
If your frame size is 730mm x 730mm then you can't move it left or right. If it smaller than that then the frame adapter will give you more leeway. I am not too sure by what you mean by "If I had a 6" board, and a stencil with cut-outs for both side
.gif)
