Electronics Forum | Fri Apr 16 19:32:07 EDT 2021 | mcoass
Hello, I have a very strange problem in a Delta 3 vitronic soltec, drops of tin are fired from the solderpot, I already adjusted the flux profile but these tin stains continue to appear, B.R
Electronics Forum | Thu Sep 02 10:41:41 EDT 2004 | dj_jago
Other way around Dave. We decided that the Delta had more in common with the Electra rather than the Vectra, the Electra being much more expensive. For example, we wanted 3 preheat zones for lead free and this would mean an exernal fluxer unit if
Electronics Forum | Tue Aug 24 05:02:55 EDT 2004 | dj_jago
Hiram, We have just had the same decision to make! I was at Vitronics Soltec, Holland about 4 weeks ago doing trials for Lead Free. The Soltec Delta machine was ultimatly chosen over price verses performance. Both machines are very capable but
Electronics Forum | Tue Jun 10 18:44:48 EDT 2008 | adamcrum
Were dealing with firmware issues for the stepper motor, as well as communications problems with the software. Vitronics is looking into it... again, but even they seemed to be stumped. You may want to ask your rep about it. Our machine is brand new,
Electronics Forum | Thu Mar 14 13:48:18 EDT 2013 | cyber_wolf
The entire oven is clean there are no blockages and the heater plates are brand new. I have worked with Vitronics technical support and gone through this thing with a fine tooth comb. I have even gone as far as to compare the exhaust and intake cap c
Electronics Forum | Thu Jan 05 15:34:55 EST 2006 | Joe Wesley
Electrovert does not seem to be cheaper. Still about 30K more than the Delta. We are investigating too, we are concerned about the dross build up and flow design in the electrovert. The Soltec Machine seems to have less of an issue and maintenance ap
Electronics Forum | Thu Aug 25 19:37:18 EDT 2005 | Dave
Hi Mark, Check out Heller's white paper link for a study done with a PCB in line with thick and thin aluminum plates to measure repeatability and delta T with loads of large mass materials. The result was less than 1 degree with their oven due to i
Electronics Forum | Mon Dec 17 02:08:21 EST 2007 | mun4o
Hi, I have a lot of solder bridge in our wave soldering process.We use SACX0307 and Surf 11 flux.the SW mashine is Vitronics delta 6622.Itry to change flux and termoprofile but results is not god.Can you halp me - recommend me some flux or other adv
Electronics Forum | Mon Oct 19 09:59:30 EDT 2015 | cbeneat
I've never had that particular problem with our machine, but I do know that if the CB pop for whatever reason the machine doesn't give an error. So I would check those, if you haven't yet. Also under options you can do an element check, see if that
Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery
Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this
