Electronics Forum | Wed Mar 28 07:02:41 EDT 2012 | JB
Brad. We have swapped the PC since the fault as we did have an old PC board lying around. I have tried the ISA card from the other working machine and that doesn't work either. Think its time to get in some help.
Electronics Forum | Fri Mar 30 10:24:24 EDT 2012 | gmcquoid
Interested in using a Board Loader or Jedec Tray feeder to position parts for Robotic assembly. Looking for a SMT equip surplus rep in Northern California.
Electronics Forum | Tue Apr 03 12:35:08 EDT 2012 | deanm
We have the same machine running the same alloy and have not seen this problem, but we're not running it nearly as much as you do. Have you asked Pillarhouse what could be happening? Try sending photos to them. They have been helpful in the past.
Electronics Forum | Tue Apr 03 13:28:11 EDT 2012 | davef
Is this related to this specific machine or this product? * Is this machine having a tough time regulating pot temperature? * Is this product dragging-out solder from the pot when it is being run so quickly? * Is this board out-gassing to create thes
Electronics Forum | Tue Apr 03 06:08:11 EDT 2012 | rpa
Hi, where can i place a manual tray feeder on OPAL XII - Assembleon. I tried to put the tray on rear side feeders positions and teached components array positions but an error occurred "software outlimits".
Electronics Forum | Tue Apr 03 08:34:38 EDT 2012 | thanh
REAR, NEXT TO TABLE UP AND DOWN. CHANGE FEEDER SET UP TO FIX TRAY. MAKE SURE YOU HAVE CORRECT NUMBER OF X,Y COMPONENTS IN TRAY AND NUMBER OF TRAY FOR THE PART.
Electronics Forum | Thu May 03 07:08:27 EDT 2012 | almoore
I'm thinking of rework, not production. In order to rework the part you have to have an expensive split vision alignment system. A simple standard change would eliminate the need for an expensive system.
Electronics Forum | Thu May 10 12:57:03 EDT 2012 | gnus
Seems like this is a common theme. It was always an uphill battle with management to get them to understand small strips costs us more time which in turn costs more money. Our management never got it so we had to think of ways around it.
Electronics Forum | Thu May 03 09:51:58 EDT 2012 | thomas31
Hello, We're looking for a AOI machine, especially for pre reflow inspection but which is also usable for post reflow. Our priority is image quality inspection and not the rate of inspection. What is your feeling/advise about MIRTEC, OMRON, VI tech
Electronics Forum | Tue May 29 07:06:03 EDT 2012 | aj
spacing is very tight but you should be able to get it right... If possible try and run it at 45 degrees over the wave and see how you get on... we had a similar problem and this improved things dramatically ( but we had a selective pallet that wa
