Electronics Forum | Sat May 28 06:43:03 EDT 2005 | steve
I have the ability to offer both SAC and SN100C lead free alloys to my customer base. What might occur if a customer is already using SAC305 in their wave and they want to save money and go to SN100C. They now are mixing, tin,silver,copper with tin,c
Electronics Forum | Wed Jun 01 03:49:30 EDT 2005 | devilhitam
I'am having a problem with 0805 component where right after placement, the component tend to move from the pad. I'am using 'horse shoe' aperture for 0805 component to resolve the solder beading issue. Does this 'horse shoe' contributing the skew/shif
Electronics Forum | Fri Jun 03 14:55:15 EDT 2005 | Bman
Both our Quad ZCR and our Conceptronic HVN-102 ovens have had blowers out with no alarms raised. We knew there were problems based on how boards were soldering, but don't count on your oven to tell you if anything is wrong with it. We verify once a
Electronics Forum | Fri Jun 03 14:31:33 EDT 2005 | Peter
I am working on an application requiring removing BGAs from a board coated with parylene. These BGAs have low standoff with less than 0.015" after SMT soldering. Can some comment on a reliable and consistent process to perform such rework? given tha
Electronics Forum | Mon Jun 13 18:03:45 EDT 2005 | peter ng
Dear James 1)Standby the part for next model. 2)during the convention period,replaced the part for the machines. 3)All the programme are following the CAD data.It's help to reduced the situation. 4)All the feeder must be in the good condition. 5)The
Electronics Forum | Thu Jun 23 03:43:45 EDT 2005 | ajaydoshi
Hi Jerry, > > Thanks for the info. Is vision > number required for the IP3? From the manual it > appears not (needed for IP1 & 2), however vision > type is required. > > Thanks, Dave We are using IP3 & placing BGA. BGA part data only for outer
Electronics Forum | Wed Jun 22 15:03:12 EDT 2005 | patrickbruneel
The only thing ammonia can do is tarnish copper and make it more difficult to solder. And the higher temp in lead-free will discolor the latex (giving it a sticky surface), but the functionality of the mask will be intact. There should be greater co
Electronics Forum | Fri Jun 24 12:03:58 EDT 2005 | ehess
I am looking for some info on our Kenco Industries, Ionic Tester. I've searched the internet, but cannot find them. Tag says Atlanta, GA, but search brings up nothing. Does anyone out there have one of these, and do you know where I can get parts?
Electronics Forum | Wed Jun 29 03:37:53 EDT 2005 | lupo
Hi, I think that the time depends on the type of stainless steel, temperature and solder alloy. For example, one of our machines is delivered with 316 stainless pot and alloy SnNi. It worked six months (120days*16hours = 1920hours) and aft
Electronics Forum | Wed Jun 29 03:23:10 EDT 2005 | dougs
We used to use a company in the uk that did this, we stopped as the results were never that good, i think the company stopped offering the service as well as no-one else wanted to have their nozzles repaired, it's best to get new nozzles in and make
