Electronics Forum | Tue Oct 11 19:57:04 EDT 2005 | hly
Hi folks, I had posted this earlier but I think there was some confusion on where the wrinkled joints were. The picture is the side view of a BGA soldered onto the PCB. I was able to take this picture becuase the BGA was at the edge of the board. I
Electronics Forum | Thu Mar 22 09:49:16 EDT 2007 | Manyhatz
You shouldn't have any problem with the SM320 doing what you're asking above. In fact I think it will do it quite better. We have a two machine TP-11 Hydra line and a two machine SM320 line and I can tell you one SM320 can get the job done better.
Electronics Forum | Fri Sep 30 12:16:28 EDT 2011 | tomattek
Our company would like to be able to inspect 0201 parts using our YesTech YTV 2050. To do this, we have purchased a doubling lens from YesTech that attaches to our top camera. The problem is, we bought our YesTech used from another CM, not from Yes
Electronics Forum | Sun Apr 11 13:48:33 EDT 2021 | ngumado28898
Hi guys, I'm a newbie for SMT field. Currently, I'm facing a problem that there were many defects such as tombstone, missing, skewed, billboarding that happened with 1 type component (Resistor 0201) with a specific supplier X (we have many supplier b
Electronics Forum | Wed Feb 21 06:11:41 EST 2007 | CL
Good Morning, We have 5 Mydata MY machines in separate lines. We are placing 0201's, uBGA's, CSP's, etc.... I cant say that we have never had accuracy problems but whatever caused the problems was identified and they are fairly accurate as far as I'
Electronics Forum | Thu Apr 11 20:35:22 EDT 2002 | davef
Messy. Messy. Messy. Consider gluing these components, until you control your process. It is unclear to us that a single factor drives these defects, but multiple factors that need to be tuned to work well together. PAD DIMENSIONS * Some SM-782 pa
Electronics Forum | Fri Oct 17 22:36:35 EDT 2008 | arosario
Hi All, We just started build a new product and I am encountering many non-wet rejects in our new product. I need help on what should I look into to improve our Yield. Please see below back ground 1. We are using DEK Infinity as printer. 2. We are mo
Electronics Forum | Tue Aug 10 16:55:19 EDT 2004 | mriddle
RS, It seems you've been doing your homework. However, the real question is what do you need to do with AOI? 1) What is your minimum cycle time? This would help you to determine the speed you need and whether "scan on the fly" is warranted. Also,
Electronics Forum | Thu May 26 16:41:00 EDT 2011 | scottp
Here's what I do: - Test Surface Insulation Resistance (we're in the high reliability market and use a test significantly harder than IPC's). I also test SIR in combination with other assembly materials like conformal coatings and wave solder flux
Electronics Forum | Fri Apr 30 10:42:40 EDT 2021 | oxygensmd
I have a customer who ask close to prototyping jobs with low volume and high-mix components. A regular job have around 5-30 pieces board but have high quantity and many type of components. All the time over 1000 pieces of parts on board from 250-350