Electronics Forum | Tue May 19 12:09:08 EDT 2020 | greezmky
Thank you all that contributed to the troubleshooting! I measured the height of 10+ parts with calipers and found the average to be around 2.15mm. In the program height was set to 2.42mm. I reduced the height to 2.15mm. I have since ran 561 boards
Electronics Forum | Thu May 01 06:35:51 EDT 2008 | kevinjm
Hi Jim, We had a similar problem with an AP-27. You could try to jumper the wires which lead in to the reed switch. Failing that you could swap out the opto module for this, in our machine it's located in rack 2-15. Rgards, Kev.
Electronics Forum | Mon Oct 20 14:56:51 EDT 2014 | rgduval
Progress!! Somehow, this morning I was able to get things almost working. I swapped cards 1 and 2 back, and then back again, so, in the same state as my last reply...set the default settings for the axes configuration...then, verified the addresses
Electronics Forum | Fri Dec 08 21:26:44 EST 2006 | billwestiet
You already have some good answers. A chemical isolation zone for RMA is a good idea. If you are looking for new see the two references you have and Austin America. If you are looking for used, see us at http://www.ietechnology.net. We presently
1 |