Electronics Forum | Sun Feb 13 14:22:17 EST 2005 | griinder
Has anyone ever ran into a 20mm pitch on a 24mm tape and reel. Our software doesnt have a setting for 20mm. we found a way around it, but i was curious as to how common this pitch is, and if other software or feeders have a 20mm setting.
Electronics Forum | Mon Feb 14 14:46:42 EST 2005 | russ
We use Samsung and our 24mm feeders have 8,12,16,and 20mm pitch settings. I have found 20mm pitch quite common. My favorite is yhe 12 on 12 our feeders don't support that, we have to put them up on 16mm feeders our cycle them 3 times on a 4mm pitch
Electronics Forum | Tue Feb 15 07:07:58 EST 2005 | bobpan
The mirae machine does have the setting for 20mm pitch....it can be set on the machine software but i dont believe its on the offline software.. thanks
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Mon Feb 14 13:25:52 EST 2005 | gregp
EIA-481 standard allows the maximum pitch on tape to be 4mm less than the tape width (12mm width and larger). So it is within the standard allowances. As for how common 20mm pitch on 24mm tape is I can not say. I am surprised a 24mm tape feeder ca
Electronics Forum | Sun Feb 03 07:36:17 EST 2019 | dfl
Hey Steve, I wrote to Bob, but he doesn't reply yet. Digging around, I found these: HANDLING COMPONENT VARIETY The adjustable Pocket Index function enables handling a variety of component tape reels or special component packaging. The following ins
Electronics Forum | Tue Aug 24 17:47:50 EDT 2010 | smtmax
I'm looking for CP6 fuji feeder. 16mm x 12mm (KO=8.3mm) 24mm x 20mm (KO=10.9mm) Please help! Thanks!
Electronics Forum | Tue Feb 15 14:25:08 EST 2000 | Sergey
Dear Sirs Good business day! I need the following feeders for CSM60 machine: - Stick feeders: 1. 20 mm x 1 2. 13 mm x 3 3. 8mm x 7 - Tape feeders: 1. 16 mm, 9" x 7 you seems to be have not this 2. 24 mm, 9" x 3 3. 32mm, 9" x 1 - Manual tray feeder
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
Electronics Forum | Thu Mar 01 06:12:18 EST 2018 | reckless
I am new to SMT and need to buy a pick n place machine that runs ~7500 cph and super reliable/no headache. My budget is $10,000. Either I buy seriously used (~15-20 years old gsm) or new Chinese unit. I saw this video and am seriously considering
.gif)
winsouce.jpg)