Electronics Forum | Wed Oct 15 15:40:21 EDT 2008 | stepheniii
255 shuts it off, but if I remember correctly 254 still uses vision but passes almost everything? You might want to give 254 a try before resorting to 255. I believe 254 will still correct some pickup offsets. And iirc 255 isn't in the manual but so
Electronics Forum | Wed Jun 07 04:44:23 EDT 2017 | dentata911
Thank you for your answer. But maximum value for modcode 7 is 255. 255x3.3 msec is 0.8 sec. And I need 2-3 seconds...
Electronics Forum | Tue Dec 27 04:07:56 EST 2016 | anhsang38
Dear Pro, Pls, increase temperature up to 255ºC and considering solder's profile. Good luck
Electronics Forum | Thu Oct 06 00:41:56 EDT 2005 | vinitverma
Hi, If you're thinking of a new machine and the volumes are not very high, I think Assembleon's OPAL XII should be the best fit. It can handle VERY LARGE boards upto 25.5" x 17" (with single pass) and 25.5" x 33.5" (with double pass). However for th
Electronics Forum | Fri Feb 15 15:55:58 EST 2008 | pjc
This is from the OmniFlo 5 Engineering data sheet: EXHAUST SPECIFICATIONS: STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unload-end: 300 cfm (510 m3/hr) at the 4� (102 mm) stack (minimum req
Electronics Forum | Mon Apr 10 00:06:44 EDT 2006 | saiwong
Fuji GP 641 is really a bad choice. Bulky, heavy, accuracy is bad. At the price that you purchased, why don't you get the Dek infinity, Horizon or even a MPM UP 2000 HiE. You paid sky high price of this printer. The market value no more than $2k. At
Electronics Forum | Mon Sep 25 16:37:18 EDT 2000 | jackofalltrades
I would have to ask the same question as Wolfgang, we use DEK's (249, 255, & 265) for whatever paste happens to required for a particular PCB, with no unique trouble.
Electronics Forum | Wed Nov 24 06:38:57 EST 1999 | carl
Hi Larry; Have you tried just to place it as a square. Or if all fails try vision 254 255. Just be carefull with this as it will place nothing if the reel runs out. Give me a call.
Electronics Forum | Thu Sep 08 09:47:20 EDT 2005 | lupo
I will try with temperature 255 C degrees. The wetting force vs. solder temperature for SAC305 is more than 265 C degrees (the temperature of trials). Thanks for the advise. Regards
Electronics Forum | Thu Mar 09 15:04:41 EST 2006 | geocominc
Please advice how can we reduce a delta T of 40 degres between pads with a seven zones reflow for a LF Assy. max 255 min 215 board size 3x5 inches.
