Electronics Forum | Wed Oct 23 10:22:55 EDT 2019 | maxwilko
Hey Kathy, Thank you for the link for the tech support will keep that in mind for the future! After a long series of testing different solutions we found that re-sending the Gerber data over to the 'My500' seems to have resolved the issue, we are n
Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit
It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower
Electronics Forum | Thu Oct 24 03:28:45 EDT 2019 | mfurlandea
Hello, i need an information about Fuji Aimex II and the problem when you have a multi offset pcb and you need to mount some offset with one program and the rest with a different program. So process dispense paste, mounting, changing program and moun
Electronics Forum | Wed Oct 30 02:12:39 EDT 2019 | jags
yes and thanks for this feedback. we clean with degreaser ( strong) and flux is rosin with 10% in the paste (koki). we clean after second reflow . the gap time from bottom to topside completion is 10 hours. cleans with this time. my even after 20 h
Electronics Forum | Thu Oct 31 11:47:00 EDT 2019 | slthomas
I've never tried OSP so can't speak to it's real world use. I only know what I've read about it (it has a shelf life and allegedly is less physically durable than ENIG) so I don't believe that it's a good fit for us. I understand that it solders
Electronics Forum | Mon Nov 04 07:31:54 EST 2019 | amitthepcbguy
As a manufacturer, I prefer plated nickel gold, electroless nickel immersion gold, immersion silver and palladium. These surface finishes are the best options to replace leaded surface finishes. These surface finishes can withstand higher temperature
Electronics Forum | Mon Nov 04 14:56:35 EST 2019 | stephendo
I think it might be the best choice for OEMs that only run one finish and practice JIT. (taking cost into account) For everyone else I think they will eventually run into trying to use them too long after they have been opened. But when you can run b
Electronics Forum | Tue Nov 05 11:53:50 EST 2019 | markhoch
Does anyone have any experience trying to solder Anticapillary or Silicone Blocked (SBT) wire? It's designed to inhibit wicking of liquids and unfortunately that includes molten solder. We're experimenting with it for a potential high volume applicat
Electronics Forum | Mon Nov 11 21:44:06 EST 2019 | kylehunter
> Knead pressure, is normally at or slightly lower > (maybe 25%) than print pressure... Ahh makes sense. Couple other quick questions if you don't mind: 1) Currently do kneading after 15 mins of no activity, with 3 knead passes, is that n
Electronics Forum | Thu Aug 27 03:19:21 EDT 2020 | dekhead
Have you done Squeegee Heights calibration? (no tools required) Does it complete cal routine without error? Does pressure compensate on next print, with corresponding squeegee, following acknowledgement of pressure error? The readings calibration, ge
