Electronics Forum | Tue Feb 17 11:35:29 EST 2009 | leeg
I have a problem with an Asys router whereby it says that I have a tool exchange error. Anyone any ideas how to get it to do an auto tool change?
Electronics Forum | Fri Oct 03 08:42:36 EDT 2003 | m4040
This is probably the most advanced machine that MPM has EVER offered. It operates in a Windows 2000 environment, which means plug and play networking. Both setup for new boards and 2D are VERY easy to set up. Most new board programming can be done of
Electronics Forum | Tue Dec 09 08:51:56 EST 2008 | pjc
256 LT or Lite, low end fully auto machine, lower res alignment camera, not as accurate and repeatable as GSX. Wiper and Auto Paste dispensing optional. GSX is fully loaded with hi end camera alignment, auto paste, vac stencil wiper, may have auto fl
Electronics Forum | Tue Oct 10 18:17:13 EDT 2006 | Dave from Ohio
We currently use both machines side by side in our lab now and LPKF is by far the better machine. Both are comparable systems to each other but the T-Tech machine always seems to have problems of some sort and their tech support department isn�t ve
Electronics Forum | Tue Jan 08 16:12:57 EST 2019 | cbeneat
We are using material control, and our auto support pins are from Quik Tool. They integrated there modules into our machines, we're happy with it. Not using auto changeover as far as I know, I stick to the maintenance side. We have a programmer that
Electronics Forum | Fri Oct 03 07:49:19 EDT 2008 | grantp
Hi, I just saw the new NXT machines at globaltronics in Singapore, and mostly they are faster. However what was interesting is Fuji shows a prototype of the new XPF machine, but it was called XPF-W which handles really large PCB's and uses the sam
Electronics Forum | Wed Jan 12 11:54:13 EST 2000 | Chen Zhou
Vishy, We have a project to study the impact of productivity lift in SMT lines using discrete event simulation tools (AutoMod is what we use). As Mr. Lahat found out, the high fidelity simulation of productivity lift is non-trivial. However, we have
Electronics Forum | Fri Aug 20 11:34:11 EDT 2004 | soease
Hi Grant, sly again. I was searching for some infos about Auto-SIR, and I found something that may interrest you; Concoat, wich is the company who sells Auto-SIR systems, also has profiling tools and they seem to have a more powerful software to ana
Electronics Forum | Fri Jul 09 11:28:24 EDT 1999 | Earl Moon
| Has anybody successfully used an automated dispensing system to put solder paste dots on .5 mm pitch pads?? I need to replace some Meritec tsop sockets and I don't want to use the single site stencils for .5 mm parts. | Carol, Don't blame you f
Electronics Forum | Wed Apr 24 13:49:19 EDT 2019 | griinder
I have a support question concerning setting the gridlock tooling in manual mode on a MPM Momentum Elite. I am printing the top side (bottom is populated with parts) of a thin, flimsy PCB. The Grid lock tooling bows the PCB upwards in Auto mode, beca
.gif)
