Electronics Forum | Fri Dec 19 17:20:17 EST 2008 | davef
We don't know dip a about rigid flex. Flexdude wrote "Hot-Bar Soldering, Attaching Flex Circuits Directly To Rigid Boards" [http://www.flexdude.com/Back%20Issues/FCN11-00A.PDF ]. It may help you get started while waiting for others reply. We have n
Electronics Forum | Mon Dec 22 09:41:20 EST 2008 | evtimov
With Hot bar you can attach flet cables to PCB or to Displays. I beleave there are a lot of machines about that. The problem is in the jig which should be made for your particular board. If you define the process and the jig, with a very simple machi
Electronics Forum | Mon Dec 29 07:23:57 EST 2008 | ghenning
Watch out for workmanship specs. I don't believe this is covered under IPC-A-610. You may have to write your own. Alignment of the fixture and coplanarity of the bar and substrate are key. Also, pay close attention to stencil aperture and thicknes
Electronics Forum | Tue Nov 15 22:27:21 EST 2011 | Jacki
Hi Zaza Thanks. Again, very appreciate if you advise me where I can get the SN100C solder bar that is water soluable. Now I'm checking Nihon Superior(Singapore) whether they have or not. As our customer's preference, we have to use the watersoluab
Electronics Forum | Thu Apr 11 10:54:34 EDT 2019 | bmalhi
NITROGEN INLET: 2000 CFH ( 56.6 m 3/H R) MAX, 100 PSI (6.9 bar) MAX, 70 PSI (4.8 bar ) MIN For service inquires you can contact Heller by e-mail ServiceNJ@hellerindustries.com or call 973-377-6800 Ext. 5.
Electronics Forum | Tue Jun 23 05:52:15 EDT 2020 | ameenullakhan
Hi dave, Thanks for the input. your valuable feedback always help. which method is better Spindle or T-bar. IPC TM 650 have are considered as standard methods. 1. T bar 2. Spindle. since we have never used it. we are bit confused. Which would be
Electronics Forum | Fri Nov 13 07:03:44 EST 2009 | davef
Loco [snip] "The print mode is another consideration. Printers are designed with a squeegee bar and a flood bar. In flood mode the flood bar spreads the paste, and in print mode the squeegee applies pressure, such that the actual printing takes plac
Electronics Forum | Wed Mar 07 20:37:38 EST 2001 | davef
I agree. The bar coded label you use should not be affected by the solder mask of the board. The label should have sharp contrast between the segments of the code to modulate the returned light and allow the reader to discriminate between light and
Electronics Forum | Wed Jun 16 14:05:23 EDT 1999 | Dave F
| A potential customer of our is inquiring if we have capability | for Hot Bar manufacturing in the PCBA manufacturing world. If someone can explain to me what this entails, I would greatly appreciate it. Thank you. | Gary: Tell your customer NO
Electronics Forum | Fri May 16 11:19:23 EDT 2003 | blnorman
In addition to the information provided above, we put a bar code label on each of our PCB's, and on 4 lines we burn in the bar code with a laser. That way we have traceability on that board throughout our process. At the end of the line another bar
