Electronics Forum | Wed Jan 17 21:19:08 EST 2007 | Jnet
I believe the drive of the conveyor whether rail or belt is the same so the sprocket choice in the software would effect belt or rail conveyor speed. I would make sure the number of teeth match the sprocket selection in the software.
Electronics Forum | Thu Oct 20 05:30:23 EDT 2005 | Slaine
Ive a 5 zone BTU vip 90 thats about 12 years old, and just lately its been a pain, its needed justabout all the fans replacing, the belt has eaten away the drive sprockets (they were fine a month ago) and just lately the belt speed has started to va
Electronics Forum | Tue May 21 13:43:17 EDT 2002 | dougt
With regards to feeders handling 0201's, how does this feeder (as well as other manufacturers feeders) keep the pick position accurate? The feeders I've used have some play between the tape and the sprocket, enough so that if I tug at the cover tape
Electronics Forum | Fri Mar 19 13:26:19 EST 1999 | Scott Cook
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Tue Oct 17 12:12:10 EDT 2017 | dustind19871
I know I have seen several old threads about this screen printer. I was curious if there was anyone out there that had any luck tracking anything down parts or info wise about these printers. I have one and I am trying to source the correct timing b
| 1 |
