Electronics Forum | Fri Nov 03 02:32:56 EST 2006 | shivam
HI ALL, can anybody clear me what is via tenting and via pluging?? second one, if i use via in pad for an.5mm bga what care i should taken, what should be the soldermask open in top and innerlayers for via?how it will directly connect to top layer
Electronics Forum | Fri Dec 17 14:30:42 EST 2004 | Dreamsniper
I goy this issue: Voids in almost every ball of my BGA's prcessed since we changed our BGA via tenting to double tenting. The tenting is done with a dry film application to fill the via from the solder side then apply LPI Mask on the surface of the
Electronics Forum | Fri Dec 17 14:31:52 EST 2004 | Dreamsniper
I got this issue: Voids in almost every ball of my BGA's processed since we changed our BGA via tenting to double tenting. The tenting is done with a dry film application to fill the via from the solder side then apply LPI Mask on the surface of the
Electronics Forum | Sun Dec 26 21:24:55 EST 2004 | tellinghuisen
Dreamsniper What is the rationale for the double plugging? And why from both sides?
Electronics Forum | Fri Jan 21 19:30:11 EST 2005 | Dreamsniper
Hi T2, The purpose of this is that we want to make our rework robust. Whenever we rework BGA's we have solder getting trapped into those 1 sided tented vias and bet yah...they are hard to desolder! And during BGA resoldering these trapped solder will
Electronics Forum | Tue Mar 22 20:33:24 EST 2005 | davef
Q1. What are you guys doing for filled/tented/plugged vias on the BGA site? A2. 2221A, 4.5.1 tells you the vias have to be tented on both sides. Q2. What type of issues can this cause if using no filled/tented/plugged vias on the BGA site? A2. BGA
Electronics Forum | Fri Jun 09 17:34:08 EDT 2000 | Melanie Mulcahy
I need some information regarding the acceptability/unacceptability of using tented vias with LPI soldermask. Long story on all involved, but basically I have a board that I have had manufactured with no problems which has BGA/uBGA parts, tented via
Electronics Forum | Tue Mar 22 08:05:59 EST 2005 | jdumont
Morning all, my question is regarding the use of filled/tented/plugged vias on the BGA site. What are you guys doing for this? What type of issues can this cause if using none, or the improper via design. Regards, JD
Electronics Forum | Fri Jan 21 16:50:33 EST 2005 | Board House
I work for a board house and our proceedure for this process is the following, We cover the via pads leaving the hole open and then apply the surface finish and then go back and Cover the Via with a second operation. By doing this you do not entrap
winsouce.jpg)