Electronics Forum | Thu Jun 09 07:23:03 EDT 2005 | ajaydoshi
We have BTU150 paragon. Frequent failure obseve in cooling fan capacitor. Cooling zone temperature reach up to 80 degree centigrade How to prevent same. ajay
Electronics Forum | Thu Jun 09 10:10:34 EDT 2005 | dougs
Are your cooling fans faulty? check these first.
Electronics Forum | Mon Jun 13 17:51:24 EDT 2005 | peter ng
Check the thermal heater,the cooling fan,the contactor breaker,it is faulty?
Electronics Forum | Mon Sep 21 10:23:46 EDT 2015 | koprivecj
Please look at folowing link. http://shrani.si/f/3l/xt/3ZHqDv6X/padconnectproblem.png I think that there would be no problem with full pouring the via. But i don't know if it is good to fully pour the PAD in inner layers? Any suggestions?
Electronics Forum | Mon Jul 30 17:31:59 EDT 2018 | dekhead
That error message is keyed by a hardware (soldered) link on the backplane board of the Y1 (motor controls), through direct cable to PCIB40#3... check connections both ehds; possibility of multiple PCIB failures?
Electronics Forum | Tue Jul 31 17:24:33 EDT 2018 | erici
There is a hardware dongle at the back of the machine. Is this the hardware link (key) you are referring to? Ok i will check the cables to PCIB40#3. Thanks again
Electronics Forum | Sat Jan 06 05:17:16 EST 2007 | shrikant_borkar
Hi. How one Can suggest you unless your Involment in your Process? Check Following Points and also Is Reflow Temp - Profile is as Per Glue Mfg. Requirment Are Glue Dot in Sysmetricl Position? Is glue sufficient , below IC to hold ? please visit th
Electronics Forum | Tue Jul 31 22:32:35 EDT 2018 | dekhead
Hardware dongle on back of machine is software key which may or may not be required for your software (depends on software version) and has nothing to do with the error you are experiencing. The hardware link to which I refer is on the Y1 backplane
Electronics Forum | Wed May 15 08:04:27 EDT 2024 | james2024
Hello, The fiber optics cable appears to be functioning correctly; transmission is evident through the blinking LEDs, and the computer can read the status of all transport sensors. I have managed to identify an error in the logs. Please use the foll
Electronics Forum | Wed Feb 07 16:16:10 EST 2007 | mr
I have seen this before. Check: --Vibration of belt --Interference (part getting "brushed off" while reflowing bottom-side components --Some glues' cross-linking mechanism is impaired by the flux during migration in reflow, redering the glue useless
.gif)
