Electronics Forum | Thu Nov 30 12:30:59 EST 2006 | cyber_wolf
Increase your PM frequency........???
Electronics Forum | Wed Nov 29 23:25:23 EST 2006 | fastek
Is this a recent happening or has it always occured since you got the oven?
Electronics Forum | Thu Nov 30 16:36:04 EST 2006 | techgonecrazy
I think we can control temp... but I will have to look into it further and see. I know the ovens have flow control... but as I mentioned on the last message, our BTUs are operating off of a huge chillers on the roof of the plant.(once again, not sure
Electronics Forum | Thu Nov 30 10:38:39 EST 2006 | billwestiet
You are cooling too fast, and some flux and paste is worse than others... Can you control your cooling zones? Water Temp (higher)? Or Water Flow (less, effectively less cooling)? Changing water temp is prefferable over flow if you can do it. I h
Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy
This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I
Electronics Forum | Wed Nov 29 16:52:35 EST 2006 | techgonecrazy
OK... My problem with BTUs is that they are getting stopped up because the flux is not going from vapor form to liquid form; instead it is crystalizing (looks like a blizzard took place in the flux box and chiller boxes) and clogging up the flux box,
Electronics Forum | Mon Sep 19 17:21:14 EDT 2005 | rick
They're full of crap and are simply trying to get you into a Paramax 150. Depending on your product you could probably get by with a VIP-98.
Electronics Forum | Sat Apr 10 08:17:21 EDT 2010 | nagesh
Dear All, I have a problem with the BTU-paragon -150 reflow oven,with the heaters getting off with Overtemperature Alaram. But the actual temperature on board not exceeding the 255 peak temp. Pls. advice & thx in advance for your sincere postings. R
Electronics Forum | Mon Apr 12 12:01:27 EDT 2010 | tommyttr
One of the air temp sensors by the blower is bad. Unplug them and check each to find the defective one.
Electronics Forum | Thu Nov 12 06:38:00 EST 2009 | nagesh
Dear All, I have a problem with the BTU-Paragon 150 10 Zone Reflow Oven. Am not able to lift the HOOD using the buttons on the Main control panel. I have checked the Lift hood switch & Ok. Pls. advice / Suggest. Thx in advance for all your sincere
.gif)
