Electronics Forum | Mon May 25 21:10:28 EDT 2009 | padawanlinuxero
Hello !! I have a problem with my wave solder oven, in one of the products we made has connectors on one side of the pcb and in the other one has SMT components the process is kinda tricky on the SMT components we use an adhesive and put to the refl
Electronics Forum | Tue May 26 11:13:49 EDT 2009 | xinxi
Is the components on the top or on the bottom of the pcb? Have you checked whether the temperature on pcb are too high when it pass through SW that it exceeds the limit that the components can take? Do check with the component manufacture for the te
Electronics Forum | Wed Jun 10 22:31:07 EDT 2009 | mgcoope
At work we use a system in which every customer uses a part with a phantom ( top level ) part and then under that we have more part numbers that are valid. So something like a surface mount resistor would be stored as something like. PPPPPPPPPPPP
Electronics Forum | Sat Aug 01 22:29:14 EDT 2009 | hohk
Here's the link to the image. It seems the forum's image feature is down? X-section view.. http://i672.photobucket.com/albums/vv88/hohk/X-sectionView.jpg Copper Strip with Adhesive Tape idea... http://i672.photobucket.com/albums/vv88/hohk/CoperStri
Electronics Forum | Sun Aug 02 19:47:16 EDT 2009 | isd_jwendell
Now that I've seen the pics... Soldering could work just fine. If you are going for large production then you could get copper discs cut and mounted in tape carrier ($$). This would make it very easy for automated equipment to assemble. Mounting a
Electronics Forum | Wed Jul 29 07:26:12 EDT 2009 | dilogic
Hi Patrick, thanks for the response. I might add some more information - we succesfully soldered some boards with the same settings of belt speed, pre-heat temp. etc. This batch of boards differs from the previous in a way that they are 4-layer. May
Electronics Forum | Fri Aug 07 07:55:30 EDT 2009 | robhs
Hi. We are planning a production run of a board that utilises the SEMTECH SLP2710P8 8-pin device (2.7 x 1.0 x 0.58mm). The part orientation on the board necessitates that the squeegee print direction approaches the stencil apertures on the long side
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Thu Aug 20 08:23:23 EDT 2009 | ratsalad
One diagnostic tool that I have found useful in the past is the "hot plate test". Place suspect components and/or PCB's on a hot plate and turn it on High. Then observe. Granted the conditions on the hot plate are not the same as in a reflow oven,
Electronics Forum | Fri Aug 21 04:43:14 EDT 2009 | ghepo
Hello, I suggest you visit the website http://www.analysispcb.com, where I found these information : PARAMETERS FOR DOUBLE “V” SCORING LEAD FREE LAMINATES Typ WEB Thickness, 1.6mm : 0.38mm (+.15/-0) "...Tg is not a good indicator of a materials’