Electronics Forum | Mon Jan 31 16:59:22 EST 2005 | frankracine
Hi Jay, Concerning you PCB, what TG do you expect to use for your lead free process? On my side I have a problem. I order PCB from Canada and from China. My PCB vendor in china is producing a lot of OSP and ENIG PCB, no HASL lead free and in Cana
Electronics Forum | Tue Jan 20 20:12:05 EST 1998 | Mario Lapointe
SMT-ASSY is a training center located in Montreal, Canada. We are currently looking for representation in these area: Maine, New Hamphire, Vermont, up to Connecticut. SMT-ASSY offers many different training programs for though hole and surface moun
Electronics Forum | Tue Jan 20 20:09:33 EST 1998 | Mario Lapointe
SMT-ASSY is a training center located in Montreal, Canada. We are currently looking for representation in these area: Maine, New Hamphire, Vermont, up to Connecticut. SMT-ASSY offers many different training programs for though hole and surface moun
Electronics Forum | Tue Dec 04 13:23:05 EST 2001 | fmonette
Hi Steve, It sounds like your product will have many moisture-sensitive devices on both sides. You should be aware of the additional controls that are required to insure the reliability of these components in a double-side reflow application. The
Electronics Forum | Mon Jul 16 10:51:09 EDT 2007 | patrickbruneel
D. Hillman, et al., �The Impact of Reflowing a Pb free Solder Alloy Using a Tin/Lead Solder Alloy Reflow Profile on Solder Joint Integrity,� International Conference on Lead-free Soldering, CMAP, Toronto, Ontario, Canada, May 24-26, 2005, http://www.
Electronics Forum | Fri Mar 31 14:09:16 EST 2000 | Garth Fitzner
I am looking for someone who has knowledge on the operation of a Quad 100. I want to bring that person in on a contract basis to train my staff. My facility is located near Edmonton, Alberta so ideally the right person would be in the western Canad
Electronics Forum | Thu Aug 05 12:28:44 EDT 2004 | jasont
Hi YuKim, Have you considered purchasing 2nd hand machines? Tekmart International Inc. can help you find a cost effective solution for your additional SMT line requirements. We have in stock and access to several of the machines you've listed; -
Electronics Forum | Thu May 23 22:17:47 EDT 2002 | davef
Not intending to undercut Mike's offer, but to compliment it. Consider asking Heraeus for guidance about cleaning the residues from reflowing your paste. Some NC flux res: * Cannot be cleaned. * Can be cleaned after a relatively short period of tim
Electronics Forum | Thu Jun 17 22:10:48 EDT 1999 | Earl Moon
| | | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | | | for example: | | | | | | Solder Bridge | | | 1.verify amount of flux been aplied. | | | 2.verify turbulance on
| 1 |
winsouce.jpg)