Electronics Forum | Tue Apr 10 10:33:08 EDT 2018 | davef
Oh, I just remembered the other thing that I wanted to mention ... Do the pads match the component leads?
Electronics Forum | Wed Apr 11 11:55:54 EDT 2018 | slthomas
Yes - every dimension that I measured on the gerbers checks out against datasheet. Presumably the parts match it as well....?
Electronics Forum | Mon Apr 16 16:24:20 EDT 2018 | slthomas
Amazingly enough, every one of these held fast where we placed them with a paste brick sized 1:1 with the thermal pad, no sectioning. Yes, there were voids, but we can live with that in this application.
Electronics Forum | Wed Apr 18 14:17:48 EDT 2018 | esoderberg
Further divide the ground block into more than 4 panes. Also think about using, assuming you have good placement of using Loctite chip bonder on two opposing corners. Lots of ways to get good results
Electronics Forum | Mon Apr 09 13:16:57 EDT 2018 | harlymh
Would you recommend a Yamaha Pick and place? In terms of reliability, accuracy, cph? We're looking for a pick and place that can deliver a 50 micron accuracy. What brands do you recommend for high accuracy placements?
Electronics Forum | Tue Apr 10 11:40:52 EDT 2018 | assuredtech
Are you using Flexa? If so what REV are you using? Needs to be 6.XXX Ed
Electronics Forum | Tue Jul 02 12:16:09 EDT 2019 | dman97
Yes we had the same problems with Flexa and our AIMEX 3. Fuji techs came in and upgraded all our software to version 6.24.0.1. This solved almost all the communication problems between server and client computers.
Electronics Forum | Tue Apr 10 05:58:41 EDT 2018 | smr
Dear All, my MPM UP2000 currently running with software vision 8.4.3 and OS Windows NT4. Possible or not to load/select the product program by using scanner ? Pls advise . . . . . Thanks
Electronics Forum | Tue Apr 10 13:55:31 EDT 2018 | robertbronx
Hi, Everyone!! In our company bough a Vitronics Soltec XPM520 Reflow but we don't have any manual of this equipment. Please I'm asking any PDF manual available. Thanks!!!! Best Regards
Electronics Forum | Wed Apr 11 12:17:05 EDT 2018 | randywoods
I need to perform maintenance. On reflow oven. I do not remeber procedure for opening. Hood for reflow oven. Vitronis Soltec XPM2.
